ユーザーズガイド ASUS A7S333

[. . . ] Motherboard A7S333 ® Checklist ii iii Features Safeguards iv 78 v Federal Communications Commission Statement This device complies with FCC Rules Part 15. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. [. . . ] 39 SB_PWR A7S333 ® A7S333 Onboard LED ON Standby Power OFF Powered Off CPU NOTCH TO INNER CORNER AMD™ CPU A7S333 ® CPU NOTCH A7S333 Socket A LEVER LOCK 80 Pins A7S333 ® 104 Pins A7S333 184-Pin DDR DIMM Sockets A7S333 ® Keyed for 1. 5v A7S333 Accelerated Graphics Port (AGP) A7S333 ® A7S333 Audio Modem Riser (AMR) Connector DSW 1 2 3 4 A7S333 ® ON A7S333 DIP Switches 1. Frequency Selection 2. Frequency Selection 3. Frequency Selection 4. Frequency Selection OFF ON JEN DSW OFF ON A7S333 ® 1 2 Jumper Mode ON A7S333 JumperFree™ Mode Setting Jumper Free (Default) 1 2 3 4 2 3 DSW 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4 ON ON ON ON A7S333 ® CPU 133MHz 100MHz 133MHz 133MHz 100MHz DRAM 166MHz 133MHz 100MHz 133MHz 100MHz A7S333 CPU External Frequency Selection ON KBPWR 1 2 2 3 +5V (Default) A7S333 ® +5VSB A7S333 Keyboard Power Setting USBPWR_12 1 2 2 3 +5V (Default) +5VSB A7S333 ® USBPWR_34 USBPWR_56 2 1 3 2 +5VSB A7S333 USB Device Wake Up +5V (Default) 2 1 3 2 BCS1 BCS2 A7S333 ® BCS1 BCS2 (BASS/CENTER) (Default) (CENTER/BASS) A7S333 Bass Center Setting AUDIO_EN A7S333 ® 1 2 Disable (Default) 2 3 Enable A7S333 Audio Codec Setting A7S333 ® CLRTC 1 2 Clear CMOS 2 3 Normal (Default) A7S333 Clear RTC RAM PS/2 Mouse (6-pin Female) PS/2 Keyboard (6-pin Female) USB 1 Universal Serial Bus (USB) 2 Parallel Port (25-pin Female) COM1 COM2 Serial Ports (9-pin Male) Game/MIDI (15-pin Female) Line Out Line In Mic 1/8" Stereo Audio Connectors TIP: If the case-mounted LED does not light, try reversing the 2-pin plug. A7S333 ® IDELED A7S333 IDE Activity LED FLOPPY NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. A7S333 ® PIN 1 A7S333 Floppy Disk Drive Connector PRI_IDE Connector PIN 1 A7S333 ® SEC_IDE Connector NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. A7S333 IDE Connectors PWR_FAN Rotation +12V GND CH_FAN A7S333 ® GND +12V Rotation CH_FAN A7S333 12-Volt Fan Connectors GND +12V Rotation A7S333 ® A7S333 iPanel Connector SIR CIR +5 V IRRX GND IRTX +5 V IR_CON NC GND NC CIRRX +5VSB NC GND NC CIRRX +5VSB CHASSIS# EXTSMI# +5V MLEDPCIRST# BATT NC AFPANEL IRRX GND IRTX SMBDATA +3VSB SMBCLK NC NC NC NC IRTX GND IRRX +5V (NC) Standard Infrared (SIR) Front View Back View ATXPWR +12. 0VDC +5VSB PWR_OK GND +5. 0VDC GND +5. 0VDC GND +3. 3VDC +3. 3VDC +5. 0VDC +5. 0VDC -5. 0VDC GND GND GND PS_ON# GND -12. 0VDC +3. 3VDC A7S333 ® A7S333 ATX Power Connectors SMB A7S333 ® 1 FLOATING SMBCLK A7S333 SMBus Connector Ground SMBDATA +3V AUX (White) CD(Black) Right Audio Channel Ground Ground Left Audio Channel A7S333 ® MODEM Modem-Out Ground Ground Modem-In A7S333 Internal Audio Connectors FP_AUDIO AGND +5VA BLINE_OUT_R A7S333 ® A7S333 Front Panel Audio Connector MIC2 MICPWR Line out_R NC Line out_L BLINE_OUT_L SMARTCON NC NC SCRREST NC SCRUI SCRRES# VCC NC SCRFET# SCRCLK NC GND NC2 A7S333 ® 1 A7S333 Smartcard A7S333 ® IEEE-1394_3 IEEE-1394_2 IEEE-1394_1 A7S333 IEEE-1394 Headers Ground Ground TPA2+ TPA2TPB2+ TPB2Ground +12V SPDIF_C GND GND 1 SPDIF_OUT +5V SPDIF_IN A7S333 ® A7S333 Digital Audio Connector USB_56 GND USBP5+ USBP5– USB Power USB_34 GND USBP3+ USBP3– USB Power 10 A7S333 ® 6 10 1 NC GND USBP4+ USBP4– USB Power 6 1 NC GND USBP2+ USBP2– USB Power 5 5 A7S333 Front Panel USB Headers A7S333 ® A7S333 LINE_IN Connector FP_LINE_IN BLINE_IN_R LINE_IN_R AGND BLINE_LIN_L ALINE_LIN_L Keyboard Lock Power LED PLED Keylock Ground +5 V Speaker Connector +5V Ground Ground Speaker +5 V MLED ExtSMI# Ground PWR Ground A7S333 ® Message LED SMI Lead Reset SW ATX Power Switch* A7S333 System Panel Connectors * Requires an ATX power supply. Reset Ground Slot 1, 2, 3, 4/5 IRQ [Auto] PCI/VGA Palette Snoop [Disabled] PCI Latency Timer [32] Primary VGA BIOS [PCI VGA Card] USB Function [Enabled] Onboard AC97 Audio Controller [Enabled] Onboard AC97 Modem Controller [Enabled] IRQ XX Used By ISA [No/ICU] DMA x Reserved for Legacy Drive [No/ICU] TSM MEM Block BASE [No/ICU] Power Management [User Defined] Help [. . . ]