ユーザーズガイド ASUS P4PE

[. . . ] Motherboard P4PE Checklist ii iii Features Safeguards iv v Federal Communications Commission Statement This device complies with FCC Rules Part 15. [. . . ] • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This class B digital apparatus complies with Canadian ICES-003. vi vii viii ix x 1 2 3 4 5 6 7 8 23 22 21 9 10 20 19 18 11 12 17 24 25 16 15 14 13 26 27 28 29 33 32 31 30 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 22. 86cm (9. 0in) PS/2KBMS T: Mouse B: Keyboard KBPWR1 USB2. 0 T: USB4 B: USB3 Socket 478 CPU_FAN1 DDR DIMM1 (64/72 bit, 184-pin module) DDR DIMM2 (64/72 bit, 184-pin module) EZ_PLUG1 PARALLEL PORT SEC_IDE PRI_IDE ATX Power Connector FLOPPY1 COM1 COM2 USB2. 0 Top: T:USB1 RJ-45 B:USB2 Top:Line In Center:Line Out Below:Mic In ATX12V1 0 1 2 3 4 5 Accelerated Graphics Port (AGP) AGP_WARN1 ® BroadCom Gbit/Fast BCM5702/4401 Ethernet PCI1 P4PE PCI2 MODEM Audio Codec SPDIF1 CLRTC1 PCI4 ASUS AUX1 CD1 Super I/O PCI6 / BlueMagic PCI Slot IEEE1394_1 IEEE1394_2 FP_AUDIO1 WPCI_USB USB_56 CHASSIS1 SMB1 IR1 IDE_LED1 VT6307 Chipset VIA PCI5 TRPWR1 ASIC with Hardware Monitor PRI_SATA SB_PWR1 PROMISE SATA Controller PCI3 SEC_SATA 4Mbit Firmware Hub GAME1 PANEL1 PRI_RAID1 Intel I/O Controller Hub (ICH4) CR2032 3V Lithium Cell CMOS Power 30. 5cm (12. 0in) Intel 845PE Memory Controller Hub (MCH) DDR DIMM3 (64/72 bit, 184-pin module) PWR_FAN1 CHA_FAN1 AGP_WARN1 ON Incorrect AGP Card ® OFF Correct AGP Card P4PE SB_PWR1 P4PE Onboard LED ON Standby Power OFF Powered Off 90 - 100 80 Pins ® P4PE 104 Pins P4PE 184-Pin DDR DIMM Sockets ® P4PE P4PE Accelerated Graphics Port (AGP) KBPWR1 1 2 ® 2 3 +5VSB P4PE +5V (Default) P4PE Keyboard Power Setting WPCI_USB ® 3 1 5 3 P4PE 4 2 Wireless PCI_USB P4PE WPCI_USB Setting 6 4 Original PCI reserved pin (Default) CLRTC1 ® P4PE 1 2 Disable (Default) 2 3 Enable P4PE Clear RTC RAM ® TIP: If the case-mounted LED does not light up, try reversing the 2-pin plug. P4PE IDE_LED1 P4PE HD Activity LED FLOPPY1 ® NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. P4PE PIN 1 P4PE Floppy Disk Drive Connector SEC_IDE NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. ® P4PE PIN 1 PIN 1 P4PE IDE Connectors PRI_IDE PRI_RAID1 ® P4PE NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. P4PE RAID IDE Connectors PIN 1 P4PE ® P4PE SATA Connectors SEC_SATA1 GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXP1 RSATA_RXN1 GND PRI_SATA1 GND RSATA_TXP2 RSATA_TXN2 GND RSATA_RXP2 RSATA_RXN2 GND CHASSIS1 Chassis Signal GND (Default) +5VSB_MB 1 ® P4PE P4PE Chassis Alarm Lead ® SMB1 P4PE FLOATING SMBCLK P4PE SMBus Connector Ground SMBDATA +3V ATXPWR1 Pin 1 +12. 0VDC +5VSB PWR_OK GND +5. 0VDC GND +5. 0VDC GND +3. 3VDC +3. 3VDC +5. 0VDC +5. 0VDC -5. 0VDC GND GND GND PS_ON# GND -12. 0VDC +3. 3VDC EZ_PLUG1 +12V GND GND +5V ® P4PE ATX12V1 +12V DC GND +12V DC GND P4PE ATX & Auxiliary Power Connectors CPU_FAN1 GND +12V Rotation ® CHA_FAN1 PWR_FAN1 Rotation +12V GND GND +12V Rotation P4PE P4PE 12-Volt Fan Connectors ® P4PE TRPWR1 Ground TRPWR P4PE Power Supply Thermal Connector P4PE ® USB+5V LP4LP4+ GND P4PE USB 2. 0 Header USB_56 1 USB+5V LP5LP5+ GND NC GAME1 ® P4PE +5V J1B2 J1CY GND GND J1CX J1B1 +5V 1 MIDI_IN J2B2 J2CY MIDI_OUT J2CX J2B1 +5V P4PE Game Connector MODEM1 ® P4PE CD1(Black) AUX1 (White) Left Audio Channel Ground Ground Right Audio Channel P4PE Internal Audio Connectors Modem-In Ground Ground Modem-Out IR1 ® Front View Back View 1 P4PE IRRX GND IRTX +5V IRTX GND IRRX +5V (NC) P4PE Infrared Module Connector IEEE1394_1 TPA0GND TPB0+12V GND IEEE1394_2 TPA1GND TPB1+12V GND TPA1+ GND TPB1+ +12V ® P4PE P4PE IEEE-1394 Connectors TPA0+ GND TPB0+ +12V 1 1 SPDIF1 SPDIFOUT GND AGND +5VA BLINE_OUT_R ® P4PE P4PE Digital Audio Connector +5V ® P4PE FP_AUDIO1 MIC2 MICPWR Line out_R NC Line out_L P4PE Front Panel Audio Connector BLINE_OUT_L Keyboard Lock Power LED PLED Keylock Ground +5 V Speaker Connector +5V Ground Ground Speaker ExtSMI# Ground PWRBIN Ground ® P4PE Reset SW SMI Lead ATX Power Switch* P4PE System Panel Connectors * Requires an ATX power supply. Reset Ground ASUS EZ Flash V1. 00 Copyright (C) 2002, ASUSTeK COMPUTER INC. [Onboard BIOS Information] BIOS Version : ASUS P4PE ACPI BIOS Revision 1002 BIOS Model : P4PE BIOS Built Date : 04/16/02 Please Enter File Name for NEW BIOS: _ *Note: EZ Flash will copy file from A:\, Press [ESC] to reboot [BIOS Information in File] BIOS Version: P4PE Boot Block WARNING!_ Flash Memory: SST 49LF004 (Y/N)? [. . . ] (Yes/No) Y - Create and Duplicate N - Create Only Start to duplicate the image. . . [. . . ]