ユーザーズガイド ASUS TERMINATOR P4 533

[. . . ] ® Checklist Features Federal Communications Commission Statement This device complies with FCC Rules Part 15. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • • • Increase the separation between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. WARNING! [. . . ] This class B digital apparatus complies with Canadian ICES-003. Safeguards 90 - 100 Power LED +5VSB PLED Speaker Connector +5V Ground Ground Speaker +5 V MLED ExtSMI# Ground PWR Ground Message LED SMI Lead Reset SW ATX Power Switch* * Requires an ATX power supply. Reset Ground LED2 LED1 USB T: Port0 B: Port1 USB2P ® UAEX ® LOUT LO2 MIC2 MIC LED3 LED2 CON1 J1 ® CON1 USB_4IN1 USB_CF 1 2 3 4 5 6 7 8 9 12 11 10 13 14 22 21 20 19 18 17 16 15 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23cm (9. 06in) Super I/O PS/2 T:Mouse B:Keyboard IOC_MB CHA_FAN1 CPU_FAN1 VGA1 ATX12V1 DDR DIMM2 (64/72-bit, 184-pin module) DDR DIMM1 (64/72-bit, 184-pin module) PARALLEL PORT P4SC-E Line Out Line In Mic In RJ-45 LANLED USB_12 T:Port0 B:Port1 ® SiS AUX1 CD1 PCI Slot 1 PCI Slot 2 USB_PWR34 MODEM1 CR2032 3V Lithium Cell CMOS Power 962LUA Chipset BUZZER1 CLRTC1 IDE_LED1 USB_56 PANEL1 USB_PWR56 Audio Codec MIC_LOUT1 USB_34 PRI_IDE1 USB_PWR12 SEC_IDE1 22. 4cm (8. 82in) Socket 478 SiS651 3C Integration Single Chip ATX Power Connector Flash BIOS FLOPPY1 P4SC-E Gold Arrow ® P4SC-E Socket 478 P4SC-E 104 Pins 80 Pins ® P4SC-E 184-Pin DDR DIMM Sockets USB_PWR12 1 2 P4SC-E 2 3 +5V +5VSB (Default) ® USB_PWR34 USB_PWR56 1 2 +5V 2 3 +5VSB (Default) P4SC-E USB Device Wake Up P4SC-E CR2032 3V Lithium Cell CMOS Power ® CLRTC1 Short solder points to Clear CMOS P4SC-E Clear RTC RAM P4SC-E SEC_IDE1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. ® P4SC-E IDE Connectors PIN 1 PRI_IDE1 FLOPPY1 P4SC-E PIN 1 NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. ® P4SC-E Floppy Disk Drive Connector P4SC-E TIP: If the case-mounted LED does not light, try reversing the 2-pin plug. ® IDE_LED1 P4SC-E IDE Activity LED ATXPWR1 P4SC-E +12. 0Volts +5V Standby Power Good Ground +5. 0 Volts Ground +5. 0 Volts Ground +3. 3 Volts +3. 3 Volts +5. 0 Volts +5. 0 Volts -5. 0 Volts Ground Ground Ground Power Supply On Ground -12. 0Volts +3. 3Volts ® ATX12V1 COM +12V DC P4SC-E ATX Power Connector COM +12V DC CPU_FAN1 P4SC-E CHA_FAN1 Rotation +12V GND ® P4SC-E 12-Volt Cooling Fan Power GND +12V Rotation P4SC-E Internal Audio Connectors MODEM1 Modem-In (to Modem) Ground Modem-Out (from Modem) P4SC-E USB Ports ® ® P4SC-E P4SC-E AUX1 (White) Left Audio Channel Ground Right Audio Channel Left Audio Channel Ground Right Audio Channel USB_34 6 USB Power USBP3– USBP3+ GND 1 USB Power USBP2– USBP2+ GND NC 10 6 5 1 USB_56 CD1 (Black) USB Power USBP3– USBP3+ GND USB Power USBP2– USBP2+ GND NC 10 5 MIC_LOUT1 P4SC-E Head set Left channel Head set Right channel ® GND 1 1 MIC PWR MIC Signal P4SC-E Microphone Header P4SC-E COM1 GAME ® CGAEX ® IOC_DC P4SC-E IOC_MB Connector Power LED +5VSB P4SC-E Speaker Connector +5V Ground Ground Speaker +5 V MLED ExtSMI# Ground PWR Ground ® PLED Message LED SMI Lead Reset SW ATX Power Switch* P4SC-E System Panel Connectors * Requires an ATX power supply. Reset Ground [. . . ]