ユーザーズガイド BRAUN 360

[. . . ] Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. • Using the special cord set (9), connect the shaver or the charging stand (12) to an electrical outlet with the motor switched off. When charging for the first time, leave the shaver to charge continuously for 4 hours. [. . . ] Subsequent charges will take about 1 hour. • A full charge provides up to 45 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles. 19 • If the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set. • 5-minute quick charge is sufficient for a shave. Charging lights (5) The green charging lights show the charge status of the batteries. The green charging light blinks when the shaver is being charged or switched on. When the battery is fully charged, all green charging lights shine permanently, provided the shaver is switched on or connected to an electrical outlet. Low-charge light (6) The red low-charge light flashes when the battery capacity has dropped below 20%, provided the shaver is switched on. Alternatively, you may clean the shaver using a brush: • Switch off the shaver. Remove the shaver Foil & Cutter cassette and tap it out on a flat surface (picture). • Using a brush, clean the inner area of the shaver head. However, do not clean the shaver Foil & Cutter cassette with a brush as this may damage it (picture). Keeping your shaver in top shape Replacement light for shaving parts / reset To maintain 100% shaving performance, replace the shaver Foil & Cutter cassette (1), when the replacement light for shaving parts (7) comes on (after about 18 months) or when worn. Foil & Cutter cassette: 32S The replacement light will remind you during the next 7 shaves to replace the Foil & Cutter cassette. Then the shaver will automatically reset the display. After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for at least 5 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time. [. . . ] The manual reset can be done at any time. Preserving the batteries In order to maintain the optimum capacity of the rechargeable batteries, the shaver has to be fully discharged (by shaving) every six months approximately. Then recharge the shaver to full capacity. [. . . ]