ユーザーズガイド BRAUN 6680

[. . . ] • Slowly close the housing by pushing it down until it locks. Charging the shaver in the Clean&Renew station Insert the shaver head down into the cleaning station. (The contacts (12) on the back of the shaver will align with the contacts (3) in the cleaning station). If required, the Clean&Renew station will start charging the shaver now. [. . . ] This may vary according to your beard growth. The best environmental temperature for charging is between 15 °C to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. 29 Description Clean&Renew™ station 1 Level indicator 2 Lift button for cartridge exchange 3 Station-to-shaver contacts 4 Start button 5 Station power socket 6 Cleaning cartridge Shaver 7 Shaver foil 8 Cutter block 9 Foil release buttons 10 Long hair trimmer Shaver display The shaver display (14) shows the charge status of the battery. During charging or when using the shaver, the respective battery segment will blink (green). When fully charged, all segments will light up for approximately one hour, provided the shaver sits in the C&R station. The red low-charge light flashes when the battery is running low. You should be able to finish your shave. Tips for the perfect shave For best results, Braun recommends you follow 3 simple steps: 1. At all times, hold the shaver at right angles (90°) to your skin. Stretch your skin and shave against the direction of your beard growth. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. • Next, switch off the shaver, press the foil release buttons (9) to remove the shaver foil (7) and cutter block (8). Then leave the disassembled shaving parts to dry. • If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil. The following quick cleaning is another alternative cleaning method: • Press the foil release buttons (9) to lift the shaver foil (do not remove the foil completely). 5–10 seconds so that the shaved stubbles can fall out. Remove the shaver foil and tap it out on a flat surface. Using a brush, clean the inner area of the shaver head. However, do not clean the shaver foil nor the cutter block with the brush as this will damage them. Cleaning the housing From time to time clean the housing of the shaver and the Clean&Renew station with a damp cloth, especially inside the cleaning chamber where the shaver rests. [. . . ] Replacing the cleaning cartridge After having pressed the lift button (2) to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. Keeping your shaver in top shape Replacing the foil and cutter block/reset To maintain 100% shaving performance, replace the shaver foil (7) and cutter block (8), when the replacement symbol (16) lights up (after about 18 months) or when cassette is worn. The replacement symbol will remind you during the next 7 shaves to replace the shaver foil and cutter block. Then the shaver will automatically reset the display. [. . . ]