ユーザーズガイド CLARION DXZ276MP INSTALLATION GUIDE

[. . . ] Install the unit within 30° of the horizontal plane. If you have to do any work on the car body, such as drilling holes, consult your car dealer beforehand. Use the enclosed screws for installation. [. . . ] Remove the Detachable Control Panel (DCP). ∗ For instructions on removing the DCP, refer to the owner’s manual. Press the outer escutcheon upward and remove it. Pull the hook plates to remove the source unit. / 3 1. 10 ∗ DCP DCP 9 “3 ” • Console opening dimensions • • 7-3/16" (182 mm) Stoppers Hole 53 mm 2-1/8" Instrument panel Hole Outer escutcheon Hexagonal bolt 2–Hook plate 2 Strap Figure 9 / 9/ 9 Figure 10 / 10 / 10 Top * This part is not provided in some models. Be sure to turn the power off when wiring. Be particularly careful where you route the wires. Keep them well away from the engine, exhaust pipe, etc. If the fuse should blow, check that the wiring is correct. If it is, replace the fuse with a new one with the same amperage rating as the original one. 11 Screwdriver Source Unit Installation direction Universal mounting bracket 3. 11 Spring Note: There are various types of fuse holder. Do not let the battery side touch other metal parts. 4. ∗ CeNET CeNET 521 0. 6 ∗ Clarion 5. 15 30 Y CeNET CCA-519 15 CeNET CCA-520 2. 5 CCA4. CeNET CeNET ∗ CeNET 2. 5m ∗ Clarion Fuse Stoppers Bottom Outer escutcheon Outer escutcheon side view Note: Before attaching the universal mounting bracket, slightly bend the spring toward the inside with your fingers and attach it to the side of car. 4. [. . . ] There are no user serviceable parts inside. If you drop anything into the unit during installation, consult your dealer or an authorized CLARION service center. 1 2 3 / CLARION CLARION -Purple/Black / - /- Connect it to the car power supply terminal for illumination. +Green / + Not used. Insulate each wire. /+ Blue wire (Auto antenna lead) 2. [. . . ]