ユーザーズガイド DENON SC-C11XG

[. . . ] Consult the amplifier's instructions. • Clipping or other problems may occur in the output waveform when using the speaker systems with a high output and the amplifier's tone controls set to the maximum. Avoid using them under these conditions. • Never play such special signals as a tape recorder's fastforwarding signals or sine waves continuously. [. . . ] • If there are walls or glass doors behind or in front of the speaker systems, use heavy curtains, etc. , to prevent resonance and reflection. • This is a low leakage flux type speaker system which can be used near television sets, etc. , but with some TV sets the colors may become blotchy. If this happens, turn off the TV's power, wait 15 to 30 minutes, and turn the power back on. The TV's self demagnetizing circuit will improve the picture. If the colors are still blotchy, move the speaker systems further away from the TV. • Also note that if there is a magnet or any device generating magnetic force nearby, interaction between this device and the speaker systems can cause the colors on the TV to become blotchy. WARNING Speaker system (SC-A11XG) • In case of setting on a shelf etc. , put four of anti-slip pad attached at the bottom. (Refer to diagram below. ) [Bottom view] Anti-slip pad Anti-slip pad Screw holes Floor-mount stand (ASS-100, 80) Ceiling suspension bracket (ASG-10, 20) [ When mounting on a stand or brackets ] The speaker system (SC-A11XG) can be mounted to a separately sold floor-mount stand (ASS-100, ASS-80) using the screw holes on the bottom (60 mm intervals) or to a ceiling suspension bracket (ASG-20) using the screw holes on the back (60 mm intervals). When mounting on a stand or bracket, follow the instructions included with the bracket or stand and be very careful to mount the speaker system securely. (See diagram above. ) [Back view] Wall mount hook Screw holes /Ceiling suspension bracket (ASG-20) [ When mounting on a wall ] The wall mount hooks on the rear panel of the speaker system (SC-A11XG) can be used to mount the speaker system on the wall. When doing so, insert the heads of screws, etc. , into the holes in the wall mount hooks. (See diagram above. ) Mount on a solid wall strong enough to withstand the weight of the speaker. Note that Denon will not be held responsible for any injuries or accidents due to the speaker falling. Speaker system (SC-C11XG) • Install the speaker system (SC-C11XG) with the front panel facing either upwards or downwards according to the place of installation. We recommend installing with the front panel facing downwards when placing the speaker system in a position above the ears, facing upwards when placing the speaker system on the floor. Adjust by affixing the included anti-slip pads (pieces of cork approx. (Refer to diagram below. ) [ Example of installation ] Speaker system (SC-C11XG) Speaker system (SC-C11XG) Speaker system (SC-T11XG) • When using the speaker system on a slippery surface (for example on tiles or a smooth wooden floor), attach the four included anti-slip pads (pieces of cork approx. (Refer to diagram below. ) [ Bottom view ] Anti-slip pad Anti-slip pad CONNECTIONS Before connecting, please consult with the instructions of your amplifier and follow them also. Be sure to turn the amplifier's power off when connecting the speaker systems. • Use the included cables to connect the input terminals on the back of the speaker systems (see diagram) to the amplifier's speaker output terminals. • Connect the speaker system for the left channel amplifier's "L" terminals, the one for the right channel to the amplifier's "R" terminals, matching the polarities (" " and " " marks). [. . . ] • To attach the net, line up the plastic holes of the net with the pegs on the cabinet and press in. CLEANING • Use a wiping cloth attached and wipe lightly to remove dirt from the cabinet and operation panel. When using chemically treated cloths, follow the precautions that have been written for them. • Do not use benzene, thinners, or other organic solvents or insecticides on the main unit since they may cause a change in quality or color. SPECIFICATIONS • SC-A11XG Type : 2-way, 2-speakers Closed box / Low-leakage-flux Speakers : 8 cm cone bass-mid 1 Super-high range 1 Input impedance : 6 /ohms Max. input : 40 watts (IEC), 100 watts (PEAK) Frequency range : 80 Hz~90 kHz Crossover frequency : approx. [. . . ]