ユーザーズガイド KYOSHO BALL BEARING SET

[. . . ] Operation is subject to the following two conditions: • • This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with manufacturer's instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • • Re-orient or relocate the receiving antenna. Washington DC: Office of the Federal Register, National Archives and Records Administration, U. S. Government Printing Office. Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This Class B digital apparatus complies with Canadian ICES-003. [. . . ] Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. 1 24 23 22 2 3 45 6 7 21 20 19 18 17 16 15 14 13 12 11 10 9 8 24. 4cm (9. 60in) PS/2KBMS COM1 RIMMB1 (16/18 bit, 184-pin module) PARALLEL PORT RIMMA2 (16/18 bit, 184-pin module) RIMMA1 (16/18 bit, 184-pin module) MAIN_FAN TR2 AUX Power Connector COM2 USBPWR CPU_FAN Intel 850 Memory Controller Hub (MCH) ATX Power Connector 1 T: Mouse B: Keyboard RIMMB2 (16/18 bit, 184-pin module) FLOPPY ® Socket 423 USB T: Port1 RJ-45 B: Port2 Top: ATX12V 1 1 SECONDARY IDE Accelerated Graphics Port (AGP Pro) PCI1 PCI2 PCI3 PCI4 BALL BEARING SET WOR CR2032 3V Lithium Cell CMOS Power Intel I/O Controller Hub (ICH2) CLRTC LED SCSILED PCI_FAN PCI5 CHASSIS IR SMB Multi I/O WOL USB2 HDDLED PANEL DIP Switches 4Mbit Firmware Hub KYOSHO ASIC with Hardware Monitor PRIMARY IDE JEN 30. 5cm (12. 0in) ® ON Standby Power BALL BEARING SET OFF Powered Off BALL BEARING SET Onboard LED SW1 ON OFF 1 2 3 4 5 6 7 8 9 10 ® BALL BEARING SET BALL BEARING SET DIP Switches ON 1. [. . . ]