ユーザーズガイド PANASONIC SDR-S200

[. . . ] SDR-S200 VQT0X38 6 1 2 3 8 1 2 9 3 4 5 6 7 < 8 9 : ; > ? [. . . ] ≥ After removing the battery, put the battery cover back in its original place. ∫ Charging the Battery When this unit is purchased, the battery is not charged. Charge the battery before using this unit. ¬ Set the power switch to [OFF]. B Connect the AC adaptor A to this unit and the AC outlet. A 1 Open this unit’s terminal cover. 2 Connect the AC adaptor to this unit’s DC input terminal [DC IN 9. 3V]. 3 Connect the AC mains lead to the AC adaptor. 4 Connect the AC mains lead to the AC outlet. ≥ The status indicator B starts blinking in red at intervals of about 2 seconds to signal that charging has commenced. Charging is completed when the lamp goes off. 1 2 3 4 ∫ Turning the unit on/off 1 ON OFF How to turn on the power Set the power switch to [ON]. The status indicator 1 lights red and, in motion picture recording mode or still picture recording mode, the lens cover opens. How to turn off the power Set the power switch to [OFF]. The status indicator goes out and the lens cover closes. ≥ If the LCD monitor is closed in motion picture recording mode or still picture recording mode, the power turns off. ∫ Selecting a language You can switch the language on the menu screen. LANGUAGE English Press the menu button, use the cursor button to select [ LANGUAGE], then select [English]. MENU ∫ Selecting a mode The Mode Dial is used to switch between recording and playback modes. Set the desired mode. Rotate the mode dial, and set the desired mode pictograph to the position shown in the illustration. ∫ Recording motion pictures Record a motion picture on the SD card. Rotate the mode dial to select The lens cover now opens automatically. . Press the record button to start recording. Ending the recording Press the record button again. ≥ ¥ and ; are red during recording. [. . . ] All Rights Reserved. F0606Nw0 ( 5000 A ) [. . . ]