ユーザーズガイド ROLAND AR-150

[. . . ] When using the AR-150/AR-150 Pro, please observe the following points in order to avoid factors (environmental vibration and sound pressure) that may hinder correct operation of the hard disk. [. . . ] • Do not place the unit in unstable locations or where it will be subject to vibration. If the location may be subject to vibration, place the unit on material that provides insulation against vibration, such as a folded blanket, so vibration is not transmitted to the unit. • If sound pressure around the AR-150/AR-150 Pro is extremely high, as when it is used in a high-volume live concert or near an amplified speaker(*1), place a folded blanket or other thick, soft material on the side of the AR-150/AR-150 Pro that is toward the source of the sound pressure in order to minimize the vibration caused by the sound pressure. • (During recording) The time counter value will gradually drift away from the total time value. Display AR-150 Time counter Total recording time Level meters Level meters Time counter Total recording time AR-150 Pro If such symptoms continue for a while, the “HDD Slow” message will appear and the recorded data will be lost at that point. If you notice the above symptoms, you should immediately move the AR-150/AR-150 Pro to a location free of vibration and sound pressure, or take the measures described above for mitigating the vibration and sound pressure. Copyright © 2006 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. AR-150 / AR-150 Pro [. . . ] If you notice the above symptoms, you should immediately move the AR-150/AR-150 Pro to a location free of vibration and sound pressure, or take the measures described above for mitigating the vibration and sound pressure. Copyright © 2006 ROLAND CORPORATION All rights reserved. [. . . ]