ユーザーズガイド ROLAND CB-SP1

[. . . ] fig. 2j fig. 4j fig. 1j CB-SP1 MADE IN CHINA 40782089 1PD © USING THE UNIT SAFELY Caution when storing your effects processor 1. SP-555 fig. 1j 3. SonicCell fig. 3j Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly. [. . . ] The specific thing that must be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the powercord plug must be unplugged from the outlet. • Never drop this product or subject it to strong impact while it contains any device. Main Specifications • Dimensions: 340 (W) x 170 (D) x 310 (H) mm 13-7/16 (W) x 6-3/4 (D) x 12-1/4 (H) inches (not including the handle) • Weight: 650 g / 1 lb 7 oz • Main Materials: polyester / polyethylene resin, polyurethane * In the interest of product improvement, the specifications and/or appearance of this unit are subject to change without prior notice. When stowing an SP-555, position it so its controllers are facing the front (the large pocket) and the connection jacks are facing upward. When stowing a SonicCell, position it so it's on its side, the controllers are facing the front (the large pocket), and the connection jacks are facing upward. The inside pad (150 x 150 mm) is detachable. At the time of purchase, it is attached at a suitable location for the SP-555/SP-404. When you're stowing a SonicCell, we recommend placing the inside pad at the center of the case. 2. SP-404 fig. 2j Important Notes • This product is a case for storing the set of SP-555, SP-404 or SonicCell. • Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. [. . . ] No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. [. . . ]