ユーザーズガイド ROLAND E-30

Lastmanualsはユーザー主導型のハードウエア及びソフトウエアのマニュアル（ユーザーガイド・マニュアル・クイックスタート・技術情報など）を共有・保存・検索サービスを提供します。製品を購入する前に必ずユーザーガイドを読みましょう!!!

もしこの書類があなたがお探しの取扱説明書・マニュアル・機能説明・回路図の場合は、今すぐダウンロード。Lastmanualsでは手軽に早くROLAND E-30のユーザマニュアルを入手できます。 ROLAND E-30のユーザーガイドがあなたのお役に立てばと思っています。

ROLAND E-30のユーザーガイドをLastmanualsがお手伝いします。

Download

マニュアル抽象的：マニュアル ROLAND E-30

詳しい操作方法はユーザーガイドに記載されています。

 [. . . ] Be very careful,  when you assemble and move the piano,  to make sure that you do not drop it on your hands or feet. To move the piano,  lift it carefully—all the while keeping it level. 

Part Check
Before you begin assembling the stand,  check that all the parts were supplied.  [. . . ] To move the piano,  lift it carefully—all the while keeping it level. 

Part Check
Before you begin assembling the stand,  check that all the parts were supplied. You will also need to have a Phillips screwdriver. 
fig. 01

5. 

Attach the speaker box to the metal parts on the inside of the side boards from underneath using screws “d” (M5 x 20 mm). Then fasten the rear with screws “d” (M5 x 20 mm) as well. 

fig. 02. e

Screw d E B D 1 2 3 4 A C d a b c 5 Screw d

Installing the Piano on the Stand
A: Side Board (left) B: Side Board (right) C: Pedal Board D: Rear Board E: Speaker Box
* *

1: Screw a (4 x 16 mm) x 2 2: Screw b (4 x 25 mm) x 4 3: Screw c (M6 x 45 mm) x 4 4: Screw d (M5 x 20 mm) x 8

6. 

Align the protruding screws (one each at right and left) on the bottom of the piano with the openings in the metal fittings on the side board,  then slide the piano forward until the screws are held in place. Fasten the piano to the stand with the screw “d” (M5 X 20 mm) (two each for the right and left). When handling the piano,  firmly grasp it at the front and back. Be careful,  so you do not get your fingers pinched. 

7. 
*
fig. 03. e

Assembly Procedure
Fasten each screw tightly,  then place the stand in a stable and horizontal place. 9. 
Connect the speaker cable to the speaker connector. Connect the pedal cord to the Pedal connector on the rear of the piano. other end into a wall socket. 
fig. 04

10. Connect the power cord to the power inlet on the piano,  then plug the

4. 

fig. 02. e

8 9
Screw c 1

10

Adjusting the Adjuster
11. Lower the adjuster at the bottom of the pedal board (by rotating it),  so
that the adjuster touches the floor. If you have the piano placed on a carpet,  lower it until it pushes into the carpet. 
fig. 05. e

Screw c 2 Screw b

Adjuster
11
3 Screw a

When Moving the Piano
Disconnect the power cord and raise the stand’s adjuster.  [. . . ] Connect the power cord to the power inlet on the piano,  then plug the

4. 

fig. 02. e

8 9
Screw c 1

10

Adjusting the Adjuster
11. Lower the adjuster at the bottom of the pedal board (by rotating it),  so
that the adjuster touches the floor.  [. . . ]

ROLAND E-30ダウンロード上のご注意

Lastmanualsはユーザー主導型のハードウエア及びソフトウエアのマニュアル（ユーザーガイド・マニュアル・クイックスタート・技術情報など）を共有・保存・検索サービスを提供します。
お探しの書類がなかったり、不完全だったり、言語が違ったり、モデル名や言語が説明と違う場合など、いかなる場合でもLastmanualsはその責を負いません。またLastmanualsは翻訳のサービスもしていません。

規約に同意して「マニュアルをダウンロード」をクリックすればROLAND E-30のマニュアルのダウンロードが開始されます。