ユーザーズガイド ROLAND GK-KIT-G

[. . . ] When handling the board, grasp it only by its edges. Avoid touching any of the electronic components or connectors. Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly. Used for instructions intended to alert the user to the risk of injury or material damage should the unit be used improperly. [. . . ] Refer all servicing to your retailer, the nearest Roland Service Center, or an authorized Roland distributor, as listed on the “Information” page. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 002b . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 003 • Never use or store the unit in places that are: • Subject to temperature extremes (e. g. , direct sunlight in an enclosed vehicle, near a heating duct, on top of heat-generating equipment); or are • Damp (e. g. , baths, washrooms, on wet floors); or are • Humid; or are • Exposed to rain; or are • Dusty; or are • Subject to high levels of vibration. • In households with small children, an adult should provide supervision until the child is capable of following all the rules essential for the safe operation of the unit. • Protect the unit from strong impact. (Do not drop it!) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 013 004 To properly drive the [GR] with the GK-KIT-G, you must adjust the height of the Divided Pickup and the sensitivity of the [GR]. These adjustments are very important if you want to take full advantage of the [GR]’s superior tracking ability. Please read the GK-KIT-G and [GR] owner’s manuals. C-13A/B cable Be sure to use the C-13A/B cable to connect the GK-KITG to the [GR]. Using any other cable may cause unnecessary problems. The C-13A/B is a locking-type cable which cannot be disconnected unless it is unlocked. Before playing, be sure to wrap the cable around the guitar strap near the strap hook. This will eliminate any unnecessary strain on the cable or the GK-KIT-G. Divided Pickup To avoid damage, be sure there is no unnecessary strain on the cable that connects the Pickup and the Controller. Never bend, twist or otherwise place undue pressure on the Pickup. [. . . ] * Mount GK Connector board so that small connection port should be placed top toward guitar surface. small connection port FOR GUITAR SIGNAL WIRING C. L WIRINGS Ø16. 3 1. Do not exceed 12Vp-p for input signal level. 2. Solder uncovered wire (silver) to the earth (ground) of the guitar. [. . . ]