ユーザーズガイド ROLAND HP-3800

[. . . ] Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your hands or feet. [. . . ] You will also need to have a Phillips screwdriver. fig. 01 Installing the Piano on the Stand 4. Align the protruding screws (one each at right and left) on the bottom of the piano with the openings in the metal fittings on the side board, then slide the piano forward until the screws are held in place. Fasten the piano to the stand with the screw “d” (M5 X 20 mm) (one each for the right and left). When handling the piano, firmly grasp it at the front and back. For clamping the rear board, press each upper portion of both side boards. Then, fasten it to the pedal board from the back using screws “b” (4 x 25 mm). Connect the pedal cord to the Pedal jack on the rear of the piano. Connect the power cord to the power inlet on the piano, then plug the other end into a wall socket. 6 2. 3. 7 Adjusting the Adjuster 8. Lower the adjuster at the bottom of the pedal board (by rotating it), so that the adjuster touches the floor. [. . . ] If you have the piano placed on a carpet, lower it until it pushes into the carpet. fig. 02. e Screw c fig. 05. e 1 Wood grain side 2 Adjuster 8 When Moving the Piano Screw b Screw a Disconnect the power cord and raise the stand’s adjuster. [. . . ]