ユーザーズガイド ROLAND KS-77

[. . . ] • Be very careful, when you assemble and move the VK-88, to make sure that you do not drop it on your hands or feet. [. . . ] • Assemble the KS-77 with the stand lying on its back, with the rear panel facing down. • Should you remove knob bolt and screws for stand, make sure to put them in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. Check the Parts Before you begin assembling the stand, check that all the parts were supplied. You will also need to have a Phillips screwdriver. A: Side Board (left) B: Side Board (right) C: Center Board D: Center Board Lower E: Front Board Assembly Procedure Stand Assembly * Assemble the KS-77 with the stand lying on its back, with the rear panel facing down. (9) Secure the VK-88 to the stand (KS-77) with the knob bolts (H) (one each left and right). A C J A A D E C B D (5) Stand the entire assembly up. B J I B F: Screw (M6 x 70 mm) x 8 (including two spares) G: Screw (M4 x 16 mm) x 2 H: Knob Bolt x 2 I: Round Nuts x 8 (including two spares) J: Cap x 2 (2) Screw one of the side boards (A) to the center board (C) and lower center board (D) using three screws (F). If you have difficulty getting the screw in, adjust the orientation of the round nut. (6) After righting the stand, check for any looseness in the screws; screw in any that are loose while the stand is in its normal position. (7) Attach the front board (E)with the screws (G) in two places. G E G * When handling the VK-88, firmly grasp it at the front and back. Be careful, so you do not get your fingers pinched. H H F I G J F F F A C D B F F When Moving the VK-88 * Disconnect the power cord, cables, music rest, and rear cover from the VK-88. [. . . ] Be careful, so you do not get your fingers pinched. H H F I G J F F F A C D B F F When Moving the VK-88 * Disconnect the power cord, cables, music rest, and rear cover from the VK-88. [. . . ]