ユーザーズガイド ROLAND KS-G8

[. . . ] KEYBOARD STAND KS-G8 • 4 1) 2) 2) 3) • • • • 4) • • • 6 5 1) 1 1) 2) 2 1) 2) 1 1) 2) 5 1) 2) (1) (1) 3) 3 1) 2) 2 3 3) 4 3) (2) 4) 6 © 04788901 1KH KEYBOARD STAND KS-G8 Caution Owner’s Manual 4 Adjust the length of the support bars. 1) Using the tuning key, remove the support bar fastening screws from the support bars. * The screws you removed will be used later. 2) According to the height at which you’re using the stand, provisionally fasten the memory locks at the position shown in the illustration. Height 1 Height 2 Height 3 Names of Things Connecting bar holder Arm Connecting bar Center support Support bar Support bar fastening screw • Before using this stand, carefully read the sections entitled: “USING THE STAND SAFELY” and “IMPORTANT NOTES” (separate sheet). [. . . ] * If you’re using the stand at height 1, the connecting bars are not needed. To avoid losing them, you can attach them to the connecting bar holder. * When the KS-G8 is shipped from the factory, the connecting bars are attached to the connecting bar holders. If you‘re using the stand at height 2, attach one connecting bar each to left and right support bars. If you’re using the stand at height 3, attach two connecting bars each to left and right support bars. * The support bars and connecting bars must be tightly fastened. Memory lock 3) Raise the support bars, lightly lift up the arm, insert each support bar into the large hole near the end, and firmly fasten it using the fastening screw you removed in step 4. Leg Height adjustment screws (x 4 ) Adjuster Memory lock 4) Fasten the memory locks. Tuning key Allen wrench 6 5 Fasten the support bars and memory locks to the stand. Make sure that none of the fastening screws or bolts are loose. If the stand rocks, adjust the height of the adjusters. Setting up the stand 1 Adjust the center support to the desired height. 1) Using the tuning key, loosen the fastening screws from the left and right memory locks that are attached to the leg. 2 Fasten the leg. Changing the height of the stand 1 Remove the memory locks and support bars from the stand. 1) Using the included tuning key, remove all four of the height adjustment screws. 2) Refer to the following illustration, and slide the center support to obtain the desired height. Setting Height Remarks When you unpack the carton, the height is in the 1 position. Height 1 645 mm 1) Place the stand as shown in the illustration, and use the included Allen wrench to remove bolt (1). 2) Raise the center support as shown in the illustration, and while holding the center support in place, use the bolt you removed to fasten the center support to the leg. [. . . ] Arm 4 Place the stand upright. Grasp the center support using both hands, and slowly raise the stand to its upright position. 6 Make sure that none of the fastening screws or bolts are loose. If the stand rocks, adjust the height of the adjusters. Copyright © 2008 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. 04788901 1KH [. . . ]