ユーザーズガイド ROLAND MPU-401AT

[. . . ] Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your hands or feet. Should you remove screws, cord clamps, or stabilizer, make sure to put them in a safe place out of children’s reach, so there is no chance of them being swallowed accidentally. 5. Put the Pedal Board on the stabilizer. [. . . ] When putting the Pedal Board on the stabilizer, first loosen the attachment screws securing the speaker box to the side boards. 9. fig. st5. e fig. st8. e Connect the speaker cable extending from the rear of the speaker box to the MPU-401AT’s speaker connector. Press the speaker cable completely into the connector so that it is securely fastened. MPU-401AT Rear Loosen the screws (in four places). Pedal Board Speaker Connecter Clip Portion Ferrite Core ■ Check the Parts Before you begin assembling the MPU-401AT, check that all the parts were supplied. You will also need to have a Phillips screwdriver. fig. st900parts. e When securing the screws, lay the entire unit sideways with the rear side of the MPU-401AT at the bottom. Secure the left side board to the speaker box with the attachment screws (in two places). Attach so that the speaker cable at the rear of the speaker box is directed to the right. Secure the right side board to the speaker box with the attachment screws (in two places). As necessary, affix cord clamps as shown in the diagram to fasten the pedal cable. fig. st9. e Cord Clamps Speaker Cord Power Cord Pedal Cord Stabilizer (right) fig. st3. e Set the stabilizer in the holes in the side boards (in six places). Stabilizer screws * When Moving the Instrument Disconnect the power cord and cables from the MPU-401AT. Then lift the piano while keeping it level, and move it with care, so that you do not drop it on your feet, or get your hands caught. Check the stability of the pedal, and make adjustments as necessary. The speaker box can also be installed so that it faces toward the rear instead of toward the front. Having the speaker box face out the rear of the instrument allows the speakers to be directed toward listeners when the back of the instrument faces the audience. fig. stsp. e Take care not to attach the left and right stabilizer to the wrong sides. fig. st900SAP 8. fig. st7. e Fasten the piano to the stand with the attachment screw (M6 x 20 mm) (one each for the right and left). Normal direction Front Rear When facing to the rear Front Rear Please don’t get your fingers pinched 7 8 When Disassembling Disassemble the unit by carrying out assembly Steps 111 in reverse order. Speaker box Speaker box Attachment Screw 4. ■ Assembly Procedure • At first, assemble the entire unit in a temporary fashion, without really tightening the screws. Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. • Be careful when assembling the MPU-401AT, so as to avoid scratching the side boards. Raise the entire assembly. [. . . ] • Be careful when assembling the MPU-401AT, so as to avoid scratching the side boards. Raise the entire assembly. When standing the assembled unit up, grasp near the speaker box, and gently raise the assembly. When Changing the Orientation of the Speaker Box Be sure to completely disassemble the unit, change the speaker box orientation, then reassemble it. fig. st4 * 4 0 6 7 1 5 9 0 - 0 2 * MPU-401AT Copyright © 2005 ROLAND CORPORATION All rights reserved. [. . . ]