ユーザーズガイド ROLAND SN-R8-09

[. . . ] No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. USING THE UNIT SAFELY Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly. Used for instructions intended to alert the user to the risk of injury or material damage should the unit be used improperly. * Material damage refers to damage or other adverse effects caused with respect to the home and all its furnishings, as well to domestic animals or pets. The symbol alerts the user to important instructions or warnings. The specific meaning of the symbol is determined by the design contained within the triangle. In the case of the symbol at left, it is used for general cautions, warnings, or alerts to danger. [. . . ] FAST: Speeds up the speed to the Fast Rate. Adjusts the time it takes the high frequency rotor to reach the newly selected speed when switching between fast and slow speeds. Adjusts the time it takes the low frequency rotor to reach the newly selected speed when switching between fast and slow speeds. Volume of the high frequency rotor Speed Tweeter Acceleration Woofer Acceleration Tweeter Level 0–15 0–15 0–127 44 17: HEXA-CHORUS Uses a six-phase chorus (six layers of chorused sound) to give richness and spaciousness to the sound. fig. MFX17 18: TREMOLO CHORUS This is a chorus effect with added Tremolo (cyclic modulation of volume). fig. MFX18 L in L out Balance D Balance W Balance D L out Balance W L in Hexa Chorus Tremolo Chorus Balance W Balance W R in Balance D Parameter Pre Delay Chorus Rate Chorus Depth Tremolo Rate #1 Tremolo Separation Tremolo Phase Balance #2 Level Value 0. 0–100. 0 ms 0. 05–10. 00 Hz, note 0–127 0. 05–10. 00 Hz, note 0–127 0–180 deg D100:0W– D0:100W 0–127 R out Description Adjusts the time until the chorus sound is heard. Modulation frequency of the chorus effect Modulation depth of the chorus effect Modulation frequency of the tremolo effect Spread of the tremolo effect Phase of the tremolo effect Volume balance between the direct sound (D) and the tremolo chorus sound (W) Output level R in Balance D Parameter Pre Delay Rate #1 Depth #2 Pre Delay Deviation Depth Deviation Pan Deviation Value 0. 0–100. 0 ms 0. 05–10. 00 Hz, note 0–127 0–20 -20– +20 R out Description Adjusts the time until chorusing is heard. Frequency of modulation Depth of modulation Adjusts the differences in Pre Delay between each chorus layer. Adjusts the difference in modulation depth between each chorus layer. Adjusts the difference in stereo location between each chorus layer. 20: The chorus layers are spaced at 60degree intervals relative to the center. Volume balance between the direct sound (D) and the chorus sound (W) Output level 0–20 Balance #3 Level D100:0W– D0:100W 0–127 45 19: SPACE-D This is a multiple chorus that applies two-phase modulation in stereo. It creates no audible modulation, yet produces a transparent chorus effect. fig. MFX19 20: STEREO CHORUS This is a stereo chorus. If the level of a following step is the same as the one preceding it, there is no change in volume. SLASH: The level is momentarily set to 0 before progressing to the level of the next step. This change in volume occurs even if the level of the following step is the same as the preceding step. Description Adjusts the time after the signal volume falls below the Threshold Level until compression is no longer applied. Adjusts the volume at which compression begins Compression ratio Adjusts the output gain. Gain of the low frequency range Gain of the high frequency range Output level Parameter Rate #1 Attack #2 Input Sync Sw Input Sync Threshold OFF, ON 0–127 Mode LEGATO, SLASH 51 Parameter Value Shuffle 0–127 Level Step 01–16 0–127 0–127 Description Timing of volume changes in levels for even-numbered steps (step 2, step 4, step 6. . . ). The higher the value, the later the beat progresses. Output level Level at each step 29: GATE Cuts the reverb’s delay according to the volume of the sound sent into the effect. Use this when you want to create an artificial-sounding decrease in the reverb’s decay. fig. MFX29 L in Gate L out R in Parameter Threshold #1 Gate Value 0–127 R out Description Volume level at which the gate begins to close Type of gate GATE: The gate will close when the volume of the original sound decreases, cutting the original sound. DUCK (Ducking): The gate will close when the volume of the original sound increases, cutting the original sound. Volume balance between the direct sound (D) and the effect sound (W) Adjusts the time it takes for the gate to fully open after being triggered. Adjusts the time it takes for the gate to start closing after the source sound falls beneath the Threshold. [. . . ] Viale delle Industrie 8, 20020 Arese, Milano, ITALY TEL: (02) 937-78300 QATAR Al Emadi Co. Box 62, Doha, QATAR TEL: 4423-554 DENMARK Roland Scandinavia A/S Nordhavnsvej 7, Postbox 880, DK-2100 Copenhagen DENMARK TEL: 3916 6200 IRAN MOCO INC. No. 41 Nike St. , Dr. Shariyati Ave. , Roberoye Cerahe Mirdamad Tehran, IRAN TEL: (021)-2285-4169 SWEDEN Roland Scandinavia A/S SWEDISH SALES OFFICE Danvik Center 28, 2 tr. S-131 30 Nacka SWEDEN TEL: (0)8 702 00 20 NORWAY Roland Scandinavia Avd. [. . . ]