ユーザーズガイド SHARP VL-EH500

[. . . ] VL-EH500 » » Quick Start Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 103 | 2 3 1 ! # @ 2 1 2 3 4 4 3 1 2 4 1 2 3 5 » å å å å ø ˚ » ¬ ¬ » 6 » ˚ « « ø ø ¬ » » » » » » ß 7 » » » ‘ » ø » ø ∆ © » » 8 » ¬ å ø ø ± — » » » » ˚ ø 9 » » ± — ø ø » » å ˚ ˚ » å 10 » ø ø » » ˚ ø “ » » » ø » ˚ 11 » » » ø ø ø ¬ ¬ ˚ ø » » » » » » » 12 » » 13 » » » » » 14 » » » » » » » 15 » » » » » » » » » » » 16 » » » » » » Ni-MH » » » 17 » » » » » 18 19 ! [. . . ] • After loading or removing the battery pack, always make sure that the battery compartment door is closed and securely locked. If it is not, the battery pack may fall out during operation. • Never remove the battery pack during recording or playback. Doing so can cause the tape to become wrapped around the drum. Note • Before loading or removing the battery pack, always make sure that the (OFF). (POWER) switch is set to Charging the Battery Pack 1 2 3 4 5 CHARGE indicator Make sure that the • The battery pack will not be charged when the (POWER) switch is set to (CAMERA) or (VCR). (POWER) switch is set to (OFF). Load the battery pack into the VIEWCAM (see page 104). Open the terminal cover on the VIEWCAM and insert the DC plug of the AC adapter into the DC IN jack on the VIEWCAM. • Do not remove the terminal cover when opening it. Terminal cover AC cable DC plug AC plug DC IN jack AC adapter Connect the AC cable to the AC adapter, then insert the AC plug of the AC adapter into a power outlet. • The (CHARGE) indicator will light up in red. When the battery is fully charged, the (CHARGE) indicator will turn from red to green. Remove the AC plug from the power outlet, the DC plug from the VIEWCAM, and close the terminal cover. • When removing the plugs, grasp the plug, not the cable. Approximate charging and operating times VR-BH22 (sold separately) 240 min. 80 min. Notes • “Charging time” is the time required to fully VR-BH12 charge a depleted battery pack at the normal (supplied) temperature of 25˚C. • The charging time may vary depending on the Charging time 120 min. ambient temperature and the condition of the Continuous battery pack. recording time • Using the (REC START/ STOP) button, the zoom and other functions, or Actual 35 min. operating time turning the power on and off frequently will increase power consumption. As a result, the actual operating time may become even shorter than those listed in the table. [. . . ] • If the cassette compartment door does not close smoothly, slide the door release and try closing the door again by pressing it in the center. • Remove the cassette if you will not use the VIEWCAM for a long period of time. 106 Camera Recording 1 2 Lock button Hold down the lock button and set the (POWER) switch to (CAMERA). Press the (RECORD START/STOP) button. • To stop recording, press the (RECORD START/STOP) button again. Playback 1 Lock button Hold down the lock button and set the (POWER) switch to (VIDEO). 2 Press the È button to select (REWIND) and rewind the tape to its start position. • To fast forward the tape, press the è button to select (FAST FORWARD). 3 Press the û button to select (PLAYBACK). • To stop playback, press the Ë button to select (STOP). Adjusting the Volume Push the (VOLUME) control lever during playback to adjust the volume to the desired level. • Push the lever to the right ( +) to increase the volume or the left ( −) to decrease the volume. Volume control lever Decrease Increase 107 [. . . ]