ユーザーズガイド YAMAHA RS130 G־

[. . . ] Especially for children, parents or an instructor should teach the children the proper manner in which to use the device. If this symbol is ignored and the equipment is used improperly, fatal injury to persons or serious damage could occur. If this symbol is ignored and the equipment is * Specifications are subject to change without notice. CAUTION used improperly, there is a danger of injury to persons handling the equipment, and material damage could occur. Always set the instrument on a flat and solid surface. Placement on a sloping, unstable surface or on steps may result in the instrument being unstable and overturning. [. . . ] Make sure all bolts are tightened firmly. Loose bolts may result in the rack overturning or parts dropping causing injury. When adjusting the height or angle, do not suddenly loosen the bolt. The pad may drop, the rack or pipes may slip, pinching or causing injury to hands or fingers. The rack may overturn or be damaged resulting in injury. Please be careful when children are close to or touching the product. The product has many pipes and arms so careless movement around the product may result in injury. Please use caution. 1 Insert the Center Bar into the tube clamps on the Left Side Asand Right Side Assembly . Then slide the tube sembly onto the Left and Right Side clamps on the Center Pipe Assemblies and tighten all fixing bolts. Tighten Attach the Center Pipe 3 Attach the Drum Pad Clamps 3-1 Insert the Hex Rod Cylinders and tighten the fixing bolts. into the Drum Pad Clamp , 3-2 to the tom tom and hi-hat Tighten 3-3 into the Pads, adjust the angle 4 Attach the Cymbal Holders 4-1 Tighten Insert the Cymbal Holders into the Cymbal Holder Clamps that are attach to the left and right sides of the Center Pipe , and tighten all fixing bolts. Attach the Cymbal Pad to the Cymbal Holders , adjust the position and tighten the fixing bolts. (Refer to the Cymbal Pad’s Owner’s Manual for instructions on attaching the cymbal pad to the cymbal holder. ) Step 4-2 Tighten 4-2 Attach the Center Bar Left Side Assembly Right Side Assembly Cymbal Pad Hex Rod Cylinder Drum Pad Clamp Cymbal Holder Tighten 2 Attach the Module Holder 2-1 Insert the Hex Rod Cylinder into the Module Holder Clamp , and tighten the fixing bolts. Left Side Assembly to the upright pipe on the Cymbal Holder Drum Pad Clamp 2-2 Step 3-1 2-3 Attach the DTXPRESS to the Module Holder . Using a screw to driver and the supplied screws, attach the Module Holder the screw hole on the bottom of the DTXPRESS. [. . . ] Using a screw to driver and the supplied screws, attach the Module Holder the screw hole on the bottom of the DTXPRESS. , with the DTXPRESS attached, Attach the Module Holder to the Module Holder Clamp . Step 3-2 Step 4-1 2-4 DTXPRESS Step 3-3 Module Holder Step 2-3 Step 2-4 Hex Rod Cylinder Step 2-1 Drum Pad Tighten Step 2-2 Attach the Module Holder Clamp After the above assembly is complete, set the Kick Pad, Hi-Hat Control Pedal, etc. [. . . ]