ユーザーズガイド ASUS A7V8X

[. . . ] Motherboard A7V8X Checklist Features Safeguards FCC/CDC statements Federal Communications Commission Statement This device complies with FCC Rules Part 15. [. . . ] • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This class B digital apparatus complies with Canadian ICES-003. xi xii 1 2 3 4 5 6 21 20 19 18 17 16 15 14 13 7 8 9 10 11 12 22 23 24 25 26 27 31 30 29 28 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 24. 5cm (9. 6in) PS/2KBMS T: Mouse B: Keyboard OVER_VOLT1 CPU_FAN1 KBPWR1 USBPWR_12 USBPWR_34 USB1. 1 T: USB0 B: USB1 Socket 462 DDR DIMM1 (64/72 bit, 184-pin module) DDR DIMM2 (64/72 bit, 184-pin module) COM2 PARALLEL PORT Top:Line In Center:Line Out Below:Mic In AUX1 CD1 0 1 2 3 4 5 Accelerated Graphics Port (AGP Pro) FP_AUDIO1 AGP_WARN1 PCI1 GBLAN or LAN Chip VIA PCI2 PCI3 ® VT8235 Chipset SMB_CON1 TRPWR1 Audio Codec MODEM1 SPEECH Controller SPDIF1 A7V8X CR2032 3V Lithium Cell CMOS Power PCI4 USBPWR_56 CLRTC1 with Hardware Monitor ASUS ASIC PROMISE SEC_ IDE1 PRI_ IDE1 PDC20376 SerialATA Controller SEC_SATA1 VIA 1394 Controller Super I/O PCI5 PCI6 USB56 IEEE1394_1 IEEE1394_2 GAME1 PRI_SATA1 SB_PWR1 CHA_FAN1 AFPANEL1 CHASSIS1 SMARTCARD1 WPCI_USB1 IR_CON1 PANEL1 IDELED1 4Mbit Firmware Hub PRI_RAID1 FLOPPY1 PWR_FAN1 30. 5cm (12. 0in) USB2. 0 Top: T: USB1 RJ-45 B: USB2 VIA KT400 Chipset ATX Power Connector COM1 DDR DIMM3 (64/72 bit, 184-pin module) AGP_WARN1 ON Incorrect AGP Card OFF Correct AGP Card SB_PWR1 ® A7V8X A7V8X Onboard LED ON Standby Power OFF Powered Off CPU NOTCH TO INNER CORNER AMD™ CPU ® A7V8X CPU NOTCH LEVER LOCK A7V8X Socket A 104 Pins ® A7V8X 80 Pins A7V8X 184-Pin DDR DIMM Sockets ® A7V8X Keyed for 1. 5v A7V8X Accelerated Graphics Port (AGP) KBPWR1 1 2 2 3 ® A7V8X +5V (Default) +5VSB A7V8X Keyboard Power Setting OVER_VOLT1 1 2 OVERVOLT ENABLE 2 3 OVERVOLT DISABLE (Default) ® A7V8X A7V8X CPU Over Voltage Setting USBPWR_12 USBPWR_34 1 2 2 3 +5V (Default) ® +5VSB A7V8X USBPWR_56 1 2 +5V (Default) 2 3 +5VSB A7V8X USB Device Wake Up CLRTC1 1 2 ® 2 3 Normal (Default) A7V8X Clear CMOS A7V8X Clear RTC RAM WPCI_USB1 ® A7V8X 4 2 3 1 6 4 5 3 Wireless PCI_USB A7V8X WPCI_USB Setting Original PCI reserved pin (Default) ® A7V8X IDELED1 A7V8X IDE Activity LED TIP: If the case-mounted LED does not light, try reversing the 2-pin plug. FLOPPY1 ® A7V8X PIN 1 NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. A7V8X Floppy Disk Drive Connector NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. ® A7V8X A7V8X IDE Connectors PIN 1 SEC_IDE1 PRI_IDE1 ® A7V8X PIN 1 A7V8X PRI_RAID Connectors PRI_RAID1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. CHASSIS1 Chassis Signal GND +5VSB_MB 1 ® A7V8X A7V8X Chassis Alarm Lead SMB_CON1 ® A7V8X FLOATING SMBCLK A7V8X SMBus Connector Ground SMBDATA +3V ATXPWR1 +3. 3VDC -12. 0VDC COM PS_ON# COM COM COM -5. 0VDC +5. 0VDC +5. 0VDC +3. 3VDC +3. 3VDC COM +5. 0VDC COM +5. 0VDC COM PWR_OK +5VSB +12. 0VDC ® A7V8X A7V8X ATX Power Connectors SMARTCARD1 NC NC SCRREST NC SCIO SCRRES# ® A7V8X A7V8X Smartcard Connector VCC NC SCPWR# SCRCLK NC GND NC2 1 CPU_FAN1 Rotation +12V GND PWR_FAN1 GND +12V Rotation ® A7V8X CHA_FAN1 GND +12V Rotation A7V8X 12-Volt Fan Connectors ® A7V8X TRPWR1 Power Supply Thermal Sensor A7V8X Thermal Sensor Connector ® A7V8X A7V8X USB 2. 0 Header ® A7V8X MIDI_IN J2B2 J2CY MIDI_OUT J2CX J2B1 +5V A7V8X Game Connector USB_56 (Blue) USB+5V LDM6 LDP6 GND GAM1 1 USB+5V LDM5 LDP5 GND NC +5V J1B2 J1CY GND GND J1CX J1B1 +5V AUX1(White) CD1(Black) MODEM1 Right Audio Channel Ground Ground Left Audio Channel Modem-In Ground Ground Modem-Out ® A7V8X A7V8X Internal Audio Connectors NC GND NC NC +5VSB CHASSIS# EXTSMI# +5V MLEDPCIRST# BATT NC IRRX GND IRTX SMBDATA +3VSB SMBCLK NC NC NC NC AFPANEL1 +5 V Connect to AFPANEL Connector IRRX GND IRTX +5 V ® A7V8X Connect to iPanel SIR NC GND NC NC +5VSB A7V8X iPanel Connector IR_CON +12V Ground TPBTPB+ TPATPA+ Ground Ground ® A7V8X IEEE1394_1 A7V8X IEEE-1394 Connectors blue IEEE 1394 connector +12V Ground TPBTPB+ TPATPA+ Ground Ground IEEE1394_2 SPDIF1 ® A7V8X SPDIF_IN +5V SPDIF_OUT GND GND 1 A7V8X Digital Audio Connector FP_AUDIO1 MIC2 MICPWR Line out_R NC Line out_L AGND +5VA BLINE_OUT_R BLINE_OUT_L ® A7V8X A7V8X Front Panel Audio Connector ® A7V8X A7V8X SATA Connectors SEC_SATA1 PRI_SATA1 GND RSATA_TXP2 RSATA_TXN2 GND RSATA_RXP2 RSATA_RXN2 GND IRRX GND IRTX +5V SIR IRTX CIRRX CIR+5V GND ® A7V8X GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXP1 RSATA_RXN1 GND Standard Infrared (SIR) Front View Back View IRTX GND IRRX +5V (NC) A7V8X Infrared Module Connector Keyboard Lock Power LED PLEDKeylock Ground PLED+ Speaker Connector +5V Ground Ground Speaker ExtSMI# Ground PWR Ground ® A7V8X Reset SW SMI Lead ATX Power Switch* A7V8X System Panel Connectors * Requires an ATX power supply. Reset Ground ASUS EZ Flash V1. 00 Copyright (C) 2002, ASUSTeK COMPUTER INC. [Onboard BIOS Information] BIOS Version : ASUS A7V8X ACPI BIOS Revision 1001 Beta 003 BIOS Model : A7V8X BIOS Built Date : 07/29/02 Please Enter File Name for NEW BIOS: _ *Note: EZ Flash will copy file from A:\, Press [ESC] to reboot [BIOS Information in File] BIOS Version: A7V8X Boot Block WARNING!_ Flash Memory: SST 49LF004 (Y/N)? [. . . ] (Yes/No) Y - Create and Duplicate N - Create Only Start to duplicate the image. . . [. . . ]