ユーザーズガイド ASUS P4C800 DELUXE

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Start flashing. . . 4-4 Bad BIOS checksum. Checking for floppy. . . Bad BIOS checksum. Configure DRAM Timing by SPD Performance Acceleration Mode DRAM Idle Timer DRAm Refresh Rate Graphic Adapter Priority Graphics Aperture Size Spread Spectrum ICH Delayed Transaction MPS Revision [Enabled] [Auto] [Auto] [Auto] [AGP/PCI] [ 64 MB] [Enabled] [Enabled] [1. 1] +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-18 4-19 OnBoard AC’97 Audio OnBoard Promise Controller Operating Mode OnBoard IEEE 1394 Controller OnBoard LAN OnBoard LAN Boot ROM Onboard Floppy Controller Serial Port1 Address Serial Port2 Address Parallel Port Address Parallel Port Mode EPP Version ECP Mode DMA Channel Parallel Port IRQ OnBoard Game/MIDI Port [Auto] [Enabled] [RAID] [Enabled] [Enabled] [Disabled] [Enabled] [3F8/IRQ4] [2F8/IRQ3] [378] [Normal] [1. 9] [DMA3] [IRQ7] [Disabled] +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-20 4-21 Advanced PCI/PnP settings WARNING: Setting wrong values in the sections below may cause system to malfunction. Plug and Play OS [No] PCI Latency Timer [64] Allocate IRQ to PCI VGA [Yes] Palette Snooping [Disabled] PCI IDE BusMaster [Enabled] IRQ3 IRQ4 IRQ5 IRQ7 IRQ9 IRQ10 IRQ11 IRQ14 IRQ15 [Available] [Available] [Available] [Available] [Available] [Available] [Available] [Available] [Available] NO: Lets the bIOS configure all the devices in the system. YES: Lets the operating system configure Plug and Play (PnP) devices not required for boot if your system has a Plug and Play operating system. Select Screen Select Item Change Option General Help Save and Exit Exit +F1 F10 ESC 4-22 USB Configuration Module Version : 2. 22. 4-5. 3 Enables USB host controllers. USB Devices Enabled : None USB Function Legacy USB Support USB 2. 0 Controller USB 2. 0 Controller Mode [8 USB Ports] [Auto] [Enabled] [HiSpeed] Select Screen Select Item Change Option General Help Save and Exit Exit USB Mass Storage Device Configuration +F1 F10 ESC 4-23 USB Mass Storage Device Configuration USB Mass Storage Reset Delay [20 Sec] No USB Mass Storage device detected Device #1 Emulation Device #2 Emulation Device #3 Emulation Device #4 Emulation Device #5 Emulation Device #6 Emulation Type Type Type Type Type Type N/A [N/A] N/A [N/A] N/A [N/A] N/A [N/A] N/A [N/A] N/A [N/A] Number of seconds POST waits for the USB mass storage device after that start unit command. +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-24 Speech Option Speech Post Reporter Report IDE Error Report System Booting [Enabled] [Disabled] [Disabled] Disable/Enable Speech. +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-25 Instant Music Option Instant Music [Disabled] Disable/Enable Instant Music feature. +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-26 Suspend Mode Repost Video on S3 Resume ACPI 2. 0 Support ACPI APIC Support BIOS -> AML ACPI table APM Configuration Hardware Monitor [Auto] [No] [No] [Enabled] [Enabled] Configure CPU. Select Screen Select Item Enter Go to Sub-screen F1 General Help F10 Save and Exit ESC Exit 4-27 APM Configuration Power Management/APM Video Power Down Mode Hard Disk Power Down Mode Suspend Time Out Throttle Slow Clock Ratio System Thermal Power Button Mode Restore on AC Power Loss Power Power Power Power Power On On On On On By By By By By RTC Alarm External Modem PCI Devices PS/2 Keyboard PS/2 Mouse [Enabled] [Suspend] [Suspend] [Disabled] [50%] [Disabled] [On/Off] [Power Off] [Disabled] [Disabled] [Disabled] [Disabled] [Disabled] Enabled or disable APM. +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-28 4-29 Hardware Monitor CPU Temperature MB Temperature Power Temperature Q-Fan Control Fan Speed Ratio CPU Fan Speed Chassis Fan Speed Power Fan Speed VCORE Voltage 3. 3V Voltage 5V Voltage 12V Voltage [44°C/111°F] [36°C/96. 5°F] [N/A] [Disabled] [11/16] [2250RPM] [XXX RPM] [XXX RPM] [1. 550V] [3. 386V] [4. 890V] [11. 900V] CPU temperature +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-30 4-31 Boot Settings Boot Device Priority Boot Settings Configuration Security Specifies the Boot Device Priority sequence. Select Screen Select Item Enter Go to Sub-screen F1 General Help F10 Save and Exit ESC Exit Boot Device Priority 1st Boot Device 2nd Boot Device 3rd Boot Device [First Floppy Drive] [PM-ST320413A] [PS-ASUS CD-S340] Specifies the boot sequence from the available devices. A device enclosed in parenthesis has been disabled in the corresponding type menu. Select Screen Select Item Change Option General Help Save and Exit Exit +F1 F10 ESC 4-32 Boot Settings Configuration Quick Boot Quiet Boot Add On ROM Display Mode Bootup Num-Lock PS/2 Mouse Support Typematic Rate Parity Check Boot to OS/2 Wait for ‘F1’ If Error Hit ‘DEL’ Message Display Interrupt 19 Capture [Enabled] [Enabled] [Force BIOS] [On] [Auto] [Fast] [Disabled] [No] [Enabled] [Enabled] [Disabled] Allows BIOS to skip certain tests while booting. This will decrease the time needed to boot the system. +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-33 4-34 Security Settings Supervisor Password User Password Change Supervisor Password Boot Sector Virus Protection [Disabled] Not Installed Not Installed <Enter> to change password. <Enter> again to disable password. +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-35 Security Settings Supervisor Password User Password Change Supervisor Password User Access Level Change User Password Clear User Password Password Check Boot Sector Virus Protection Installed Not Installed [Full Access] [Setup] [Disabled] <Enter> to change password. <Enter> again to disable password. +F1 F10 ESC Select Screen Select Item Change Option General Help Save and Exit Exit 4-36 4-37 Exit Options Exit & Save Changes Exit & Discard Changes Discard Changes Load Setup Defaults Exit system setup after saving the changes. F10 key can be used for this operation. Select Screen Select Item Enter Go to Sub-screen F1 General Help F10 Save and Exit ESC Exit 4-38 4-39 4-40 ® ® 5-19 5-20 5-21 / 2 4 6 Mic Mic / 5-22 CD ON/OFF PLAY/PAUSE STOP/EJECT PREVIOUS NEXT VOL. UP Esc F1 F2 F3 F4 F5 F6 F7 F8 5-23 CD ON/OFF CAPS LOCK LED SCROLL LOCK LED PLAY/PAUSE STOP/EJECT PREVIOUS VOL. UP 5-24 ® 5-25 5-26 MBFastTrak378 (tm) BIOS version 1. 00 (c)2000-2005 Promise Technology, Inc. [. . . ] (Yes/No) Y - Create and Duplicate N - Create Only 5. <Ctrl-Y> Start to duplicate the image. . . [. . . ]