ユーザーズガイド ASUS W5FE

[. . . ] ノートパソコン ハードウ ェアユーザーマニュ アル J3095 / 2007年２月 もく じ もくじ Table of Contents 1. ノートパソコンの概要 本マニュアルについて 6 本マニュアルの表記について 6 ノートパソコンを準備する 9 2. 各部の名称と説明 上面 12 底面 14 左側 16 右側 18 背面 20 3. 使用の手引き パワーシステム 22 ACアダプターを使用する 22 バッテリーパックを使用する 23 バッテリーの取り扱い方 23 電源をオンにする 24 パワーオンセルフテスト (POST) 24 バッテリーの残量の確認 25 バッテリーパックを充電する 26 再起動 27 電源をオフにする 27 キーボードを使用する 28 彩色されたホットキー 28 Microsoft Windows キー 30 キーボードを数値キーパッドとして使う  30 キーボードをカーソルとして使う 30 スイッチとステータスインジケータ 31 スイッチ 31 ステータスインジケータ 33 マルチメディアコントロールキー(特定モデルのみ) 34 SideView (特定モデルのみ) 35  もく じ もくじ（続き） 4. [. . . ] CTR 21 (Common Technical Regulation) for the attachment requirements for connection to the analogue public switched telephone networks of terminal equipment (excluding terminal equipment supporting the voice telephony justified case service) in which network addressing, if provided, is by means of dual tone multifrequency signalling. Network Compatibility Declaration Statement to be made by the manufacturer to the Notified Body and the vendor: “This declaration will indicate the networks with which the equipment is designed to work and any notified networks with which the equipment may have inter-working difficulties” Network Compatibility Declaration Statement to be made by the manufacturer to the user: “This declaration will indicate the networks with which the equipment is designed to work and any notified networks with which the equipment may have inter-working difficulties. The manufacturer shall also associate a statement to make it clear where network compatibility is dependent on physical and software switch settings. It will also advise the user to contact the vendor if it is desired to use the equipment on another network. ” Up to now the Notified Body of CETECOM issued several pan-European approvals using CTR 21. The results are Europe’s first modems which do not require regulatory approvals in each individual European country. Non-Voice Equipment Answering machines and loud-speaking telephones can be eligible as well as modems, fax machines, auto-dialers and alarm systems. Equipment in which the end-to-end quality of speech is controlled by regulations (e. g. handset telephones and in some countries also cordless telephones) is excluded. 付録 A 内蔵モデムの適応規格 （続き） Country Applied Austria1 Yes Belgium Yes Czech Republic No Denmark1 Yes Finland Yes France Yes Germany Yes Greece Yes Hungary No Iceland Yes Ireland Yes Italy Still Pending Israel No Lichtenstein Yes Luxemburg Yes The Netherlands1 Yes Norway Yes Poland No Portugal No Spain No Sweden Yes Switzerland Yes United Kingdom Yes This table shows the countries currently under the CTR21 standard. More Testing No No Not Applicable Yes No No No No Not Applicable No No Still Pending No No No Yes No Not Applicable Not Applicable Not Applicable No No No This information was copied from CETECOM and is supplied without liability. For updates to this table, you may visit http://www. cetecom. de/technologies/ctr_21. html National requirements will apply only if the equipment may use pulse dialling (manufacturers may state in the user guide that the equipment is only intended to support DTMF signalling, which would make any additional testing superfluous). 1 In The Netherlands additional testing is required for series connection and caller ID facilities. A 付録 Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. The use of a shielded-type power cord is required in order to meet FCC emission limits and to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. (Reprinted from the Code of Federal Regulations #47, part 15. 193, 1993. Washington DC: Office of the Federal Register, National Archives and Records Administration, U. S. [. . . ] Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan sousittelemaan tyyppiin. Hävitä käytetty paristo valmistagan ohjeiden mukaisesti. Il y a danger d’explosion s’il y a remplacement incorrect de la batterie. [. . . ]