ユーザーズガイド BOSE MIE 1 DATASHEET

[. . . ] • Do not use this headset when operating a motor vehicle on a public road, or where the inability to hear outside sounds may present a danger to you or others. Use of headsets is not recommended even if they are used only in one ear and is illegal in some areas. • When using the headset while walking, be aware of motor vehicles and street conditions around you so as to prevent accident or injury. CAUTIONS: • Sounds that you rely on as reminders or warnings may have an unfamiliar character when using the headset. Be aware of how these sounds may vary in character so you can recognize them as needed. [. . . ] Note: Some phones may require you to press and hold the Answer/End button for a few seconds to perform functions. Answering calls When you receive an incoming call, press and release the Answer/End button to answer. Ending calls You can use the headset with your mobile phone by: 1. Plugging the headset into the headphone/headset jack on the phone. Once connected, you should experience: • Stereo sound to be heard during music playback and communications • Your voice to be heard by the person on the other end of a phone call • The Answer/End button to operate as expected Note: Some unique phone and music playback functions, like last number redial, voice commands, and track navigation are devicedependant, and may be accessible using the Answer/End button. Refer to your mobile phone user’s manual to find out what features are available. When you are ready to end your call, press and release the Answer/ End button. English Using a single earpiece The Bose® mobile in-ear headset can be used with only the right (R) earpiece in your ear. This allows you to take calls and still hear surrounding sounds. Changing ear tips Gently remove the existing ear tip by peeling up from its large rounded side. Slide the new ear tip over the nozzle of the headset. Press the ear tip securely into place until you feel it latch. Importance of Proper Fit Correct ® Incorrect The Bose mobile in-ear headset is designed to rest comfortably in the bowl of the ear. The soft silicone ear tip provides enough contact to secure the headset in place comfortably. Three sizes of ear tips are provided to help you customize the headset to your individual needs. Do not attempt to wear the headset without the ear tips. English Adjusting for comfort and stability There are several ways you can change your headset to provide additional comfort and stability. Using the adjustment slider, the clothing clip, and lanyard stability accessories, you can customize how you wear your headset. Using the lanyard The included lanyard provides additional stability to your headset. You can use the lanyard on its own, or with the clothing clip for even greater stability. Attach the headset cord through the right (R) and left (L) lanyard connectors below the microphone and approximately 10 inches (25. 4 cm) below each ear piece. Make sure the L and R marks point up toward the ear pieces. Pull the lanyard over your head and allow it to rest behind your neck. Adjust the lanyard connectors have enough slack above the lanyard connectors so that any downward pulls on the plug end of the cord are not felt in the ears. Note: Lanyard has a built-in safety release that separates when forcefully pulled. Using the adjustment slider Move the adjustment slider up or down to reduce or increase the amount of loose cord between the left and right earpiece. Finding the right position for the slider can help optimize the placement of the Answer/End button and integrated microphone. Using the clothing clip Use the clothing clip to fasten the cable to your clothing, for convenience, stability, and to help manage the cable. This can be helpful during high-movement activities or when using the headset in a single earpiece configuration. The clothing clip should be attached below the Y-joint and be positioned to allow natural head movement, while keeping the microphone near your mouth. English Troubleshooting If you experience any trouble using your headset, try the following troubleshooting instructions. If you still need help, see the contact information on the inside back cover for assistance in your area. Problem No audio/Intermittent Excessive bass Low volume/poor audio Microphone is not picking-up sound What to do Make sure that the headset plug is securely connected to the headphone/headset jack. [. . . ] Details of the limited warranty are provided on the warranty card that is included in the carton. What you must do to obtain Limited Warranty Service: Return product, with proof of purchase from an authorized Bose dealer, using the following procedures: 1. Contact the Bose organization in your country/region (visit Global. Bose. com for Bose contact information in your country/region) for specific return and shipping instructions; 2. Label and ship the product, freight prepaid, to the address provided by the Bose organization in your country; and 3. [. . . ]