ユーザーズガイド BRAUN 4735

[. . . ] • If the rechargeable battery has run out of power (discharged), you may also shave by connecting the shaver to an electrical outlet via the special cord set. Shaver display The shaver display (7) shows the charge status of the battery. Model 560: During charging or when using the shaver, the respective battery segment will blink (green). When fully charged, all segments will light up continuously, provided the shaver is switched on or connected to an electrical outlet. [. . . ] (Modell 4735: 1 charging segment only. ) The red low-charge light flashes when the battery is running low. You should be able to finish your shave. Description 1 2 3 4 5 6 7 8 9 10 11 Shaver foil Cutter block Foil release buttons Long hair trimmer Comfort setting switch «sensitive» On/off switch Shaver display Replacement light for shaving parts Shaver power socket Special cord set Etui Shaving Press the on/off switch (6) to operate the shaver. Comfort setting switch «sensitive» Setting the shaver head according to your comfort needs. The «sensitive» switch (5) provides three options for comfort setting: Charging The best environmental temperature for charging is between 15 °C and 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time. • Using the special cord set (10), connect the shaver to an electrical outlet with the motor switched off and charge it for at least one hour. • A full charge provides up to 45 minutes of cordless shaving time. This may vary according to your beard growth. 1 «+»: The shaver head is in full swing, freely follows the contours of your skin to provide more comfort. 2 middle position: The shaver head is semi-fixed for more control. 3 «–»: The shaver head is fixed for full control and precise handling in hard to reach areas. Regular cleaning ensures better shaving performance. Rinsing the shaving head under running water after each shave is an easy and fast way to keep it clean: • Switch the shaver on (cordless) and rinse the shaver head under hot running water. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds. • Next, switch off the shaver, press the foil release buttons (3) to remove the shaver foil (1) and cutter block (2). Then leave the disassembled shaving parts to dry. • If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil. The following quick cleaning is another alternative cleaning method: • Press the foil release buttons (3) to lift the shaver foil (do not remove the foil completely). [. . . ] • If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil. The following quick cleaning is another alternative cleaning method: • Press the foil release buttons (3) to lift the shaver foil (do not remove the foil completely). 5–10 seconds so that the shaved stubbles can fall out. [. . . ]