ユーザーズガイド BRAUN 590 CC QUICK GUIDE

[. . . ] 11 12 13 14 15 16 17 18 19 Comfort setting switch «sensitive» Shaver-to-station contacts On/off switch Shaver display Cleaning light (yellow) Replacement light for shaving parts Shaver power socket Special cord set Etui A Before shaving Prior to first use, you have to connect the shaver to an electrical outlet using the special cord set (18) or alternatively, proceed as follows: Installing the Clean&Renew station • Using the special cord set (18), connect the station power socket (5) to an electrical outlet. • Press the lift button (2) to open the housing • Hold the cleaning cartridge (6) down on a flat, stable surface (e. g. • Carefully remove the lid from the cartridge. [. . . ] The «sensitive» switch (11) provides three options for comfort setting: Cleaning For best shaving results, we recommend cleaning the shaver in the station after each shave (see «Automatic cleaning»). All charging and cleaning needs are then automatically taken care of. Cleaning indicator Clean your shaver in the Clean&Renew station at the latest when the yellow cleaning light (15) shines constantly after shaving. If this is not done, the cleaning light will go off after some time and the counter will be reset. 1 «+»: The shaver head is in full swing, freely follows the contours of your skin to provide more comfort. 2 middle position: The shaver head is semi-fixed for more control. C Automatic cleaning The Clean&Renew has been developed for cleaning, charging and storing your shaver. After each shave, return the shaver to the Clean&Renew station and proceed as follows: • Insert the shaver head down into the cleaning station. The cleaning process will start (approx. • Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use. 3 «–»: The shaver head is fixed for full control and precise handling in hard to reach areas. Long hair trimmer To trim sideburns, moustache or beard, slide the long hair trimmer (10) upwards. 30 • • • • If interruption is needed nonetheless, press the start button (4). When cleaning is finished, the yellow cleaning light will go off and the shaver is ready for use. A cleaning cartridge should be sufficient for about 30 cleaning cycles. When the level indicator (1) has reached the «min» mark, the remaining fluid in the cartridge is sufficient for about 5 more cycles. Then the cartridge should be replaced, when used daily approx. The hygienic cleaning cartridge contains alcohol, which once opened will naturally evaporate slowly into the surrounding air. Each cartridge, if not daily used, should be replaced after approximately 8 weeks. [. . . ] 31 D Manual cleaning The shaver head is suitable for cleaning under running tap water. Warning: Detach the shaver from the power supply before cleaning the shaver head in water. While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time. Accessories Available at your dealer or Braun Service Centres: • Shaver foil and cutter block: 51S • Cleaning cartridge Clean&Renew: CCR Environmental notice This product contains rechargeable batteries. [. . . ]