ユーザーズガイド BRAUN PROFESSIONAL CARE

[. . . ] • This appliance is not intended for use by children or persons with reduced physical, sensory or mental capabilities, unless they are given supervision by a person responsible for their safety. In general, we recommend that you keep the appliance out of reach of children. Children should be supervised to ensure that they do not play with the appliance. [. . . ] Therefore you must not exchange or manipulate any part of it. Otherwise there is a risk of electric shock. Description 1 2 3 4 5 6 7 8 9 10 11 12 13 Distance comb Cutting system Release button for cutting system Length settings Length selector On/off switch Pilot light (HC 50 only) Cord socket Special cord set Barber’s comb Barber’s scissors Light machine oil Cleaning brush Technical specifications Power supply: 100–240 V~ / 50–60 Hz Wattage: 7W 18 Charging the clipper (HC 50 only) When charging for the first time or when the appliance is not used for a few months, leave the appliance to charge continuously for 4 hours. The charging light shows that the appliance is being charged. When the battery is fully charged, the charging light turns off. Intermittent blinking after a while indicates that the battery maintains its full capacity. This can also happen short term when charging after the battery was completely discharged. Once the clipper is completely charged, use it without the cord until discharged. Then recharge to full capacity again (1 hour). A full charge will give up to 30 minutes of cordless trimming depending on your hair. To start clipping, shift the on/off switch to «on». Move the cutting system only in a parallel position to the skin (A, cutting hair). Slowly and carefully move the appliance against the direction of hair growth. Only when trimming contours should the cutting system be positioned vertically (B, trimming). Make sure you do not tilt the appliance while it is touching the skin (C). Avoid jerky movements while cutting. Clipping with the barber’s comb To cut longer hair, hold it up with the barber’s comb (10) and cut it with the scissors (11) or with the clipper (distance comb must be removed from the clipper – only possible at setting «1»). Keeping your clipper in top shape After each use and when the distance comb is taken off, slightly shake or brush hair from the clipper and the distance comb. Press the release button (3) to open the cutting system (2). Using the brush (13), clean the cutting system and the inside of the clipper. To keep the cutting system working properly, oil it with light machine oil after each use (D). [. . . ] Then click the cutting system back to its original position. After use, unplug the cord from the appliance for longer cord life. Preserving the rechargeable battery (HC 50 only) In order to optimise the capacity and life of the battery, it should be fully discharged through regular use every 6 months approximately. [. . . ]