ユーザーズガイド CAMPINGAZ WOODY

[. . . ] Operation is subject to the following two conditions: • • This device may not cause harmful interference, and This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Operation is subject to the following two conditions: • • This device may not cause harmful interference, and This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with manufacturer’s instructions, may cause harmful interference to radio communications. • Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This class B digital apparatus complies with Canadian ICES-003. v vi • • • vii viii ix x 1-1 1-2 1 2 3 4 5 6 19 18 17 16 15 7 8 9 10 11 14 13 12 20 21 22 23 24 25 29 28 27 26 1-3 1-4 1-5 24. 5cm (9. 64in) T: Mouse B: Keyboard PS/2 KBPWR1 Socket 462 DDR DIMM1 (64/72 bit, 184-pin module) DDR DIMM2 (64/72 bit, 184-pin module) CPU_FAN1 USB3 USB4 COM1 USBPWR_34 DDR DIMM3 (64/72 bit, 184-pin module) PARALLEL PORT USBPWR_12 Bottom: Top:Line In Center:Line Out Below:Mic In 0 1 2 3 4 5 SEC_IDE1 PWR_FAN1 Realtek RTL8201 CHA_FAN1 Accelerated Graphics Port (AGP Pro) AGP_WARN1 CD1 FPAUDIO1 2Mb BIOS PCI 1 AUX1 Audio Codec nForce2 MCP Chipset SPDIF1 PCI 2 ® Super I/O WOODY CR2032 3V Lithium Cell CMOS Power CLRTC1 COM2 USB56 PCI 3 PCI 4 MODEM1 PWR_LED1 USBPWR_56 GAME1 PCI 5 with Hardware Monitor PWRTMP1 CAMPINGAZ ASIC IR_CON1 SMB1 IDELED1 CTRL_PANEL1 CHASSIS1 BUZZ1 1-6 PRI_IDE1 30. 5cm (12. 0in) USB1 RJ-45 USB2 Top: CPU_FSB nForce2 SPP (Ultra400) Chipset FLOPPY1 nVidia ATX Power Connector CPU NOTCH TO INNER CORNER LOCK LEVER ® WOODY AMD™ CPU CPU NOTCH WOODY Socket 462 1-7 104 Pins ® WOODY 80 Pins WOODY 184-Pin DDR DIMM Sockets 1-8 AGP Card without Retention Notch ® WOODY TOP VIEW 20-pin bay Rib (inside slot) 28-pin bay Rib WOODY Accelerated Graphics Port (AGP8X) 1-9 USBPWR_12 USBPWR_34 1 2 +5V (Default) 2 3 +5VSB USBPWR_56 ® WOODY 1 2 +5V (Default) 2 3 +5VSB WOODY USB Device Wake Up CPU_FSB 1 2 ® 2 3 FSB200 WOODY FSB400/333/266 (Default) WOODY CPU FSB Jumper Setting 1-10 CLRTC1 1 2 ® 2 3 Clear CMOS WOODY Normal (Default) WOODY Clear RTC RAM KBPWR1 1 2 +5V (Default) ® 2 3 +5VSB WOODY WOODY Keyboard Power Setting 1-11 SEC_IDE1 ® WOODY PIN 1 WOODY IDE Connectors 1-12 PRI_IDE1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. FLOPPY1 NOTE: Orient the red markings on the floppy ribbon cable to PIN 1 ® WOODY PIN 1 WOODY Floppy Disk Drive Connector ATXPWR1 +3. 3VDC -12. 0VDC COM PS_ON# COM COM COM -5. 0VDC +5. 0VDC +5. 0VDC +3. 3VDC +3. 3VDC COM +5. 0VDC COM +5. 0VDC COM PWR_OK +5VSB +12. 0VDC ® WOODY WOODY ATX Power Connector 1-13 1-14 ® WOODY USB 2. 0 Header ® WOODY WOODY MIDI_IN J2B2 J2CY MIDI_OUT J2CX J2B1 +5V WOODY Game Connector USB56 1 GAME1 +5V J1B2 J1CY GND GND J1CX J1B1 +5V USB+5V USB_P5USB_P5+ GND USB+5V USB_P6USB_P6+ GND NC CPU_FAN1 Rotation +12V GND PWR_FAN1 CHA_FAN1 GND +12V Rotation ® WOODY WOODY 12-Volt Cooling Fan Power CHASSIS1 +5Volt (Power Supply Stand By) Chassis Signal Ground 1 ® WOODY WOODY Chassis Open Alarm Lead GND +12V Rotation 1-15 FPAUDIO1 AGND +5VA BLINE_OUT_R ® WOODY WOODY Front Panel Audio Connector ® WOODY TIP: If the case-mounted LED does not light, try reversing the 2-pin plug. WOODY IDE Activity LED ON Incorrect AGP Card MIC2 MICPWR Line out_R NC Line out_L IDELED1 WARNING1 BLINE_OUT_L OFF Correct AGP Card PWR_LED1 ® WOODY WOODY Onboard LED ON Standby Power OFF Powered Off 1-16 MODEM1 CD1 (Black) AUX1 (White) Right Audio Channel Left Audio Channel Modem-In Ground Ground Modem-Out Ground Right Audio Channel Left Audio Channel ® WOODY WOODY Internal Audio Connectors PWRTMP1 ® WOODY PWRTMP Ground WOODY Power Supply Thermal Connector GND GND 1 SPDIF1 +5V ® WOODY WOODY Digital Audio Connector SPDIF_OUT SPDIF_IN Ground 1-17 IR_CON1 +5 V IRRX GND IRTX Standard Infrared (SIR) Front View Back View SIR CIR NC GND NC CIRRX +5VSB ® WOODY IRTX GND IRRX +5V (NC) WOODY Infrared Connector SMB1 ® WOODY 1 FLOATING SMBCLK WOODY SMBus Connector 1-18 Ground SMBDATA +3V Keyboard Lock Power LED PLEDKeylock Ground PLED+ Speaker Connector +5V Ground Ground Speaker ExtSMI# Ground PWR GND ® WOODY Reset SW SMI Lead ATX Power Switch* WOODY System Panel Connectors * Requires an ATX power supply. Reset Ground 1-19 2-1 \ \AWDFLASH\ \ \ \ \ \ 2-2 2-3 2-4 2-5 2-6 2-7 2-8 2-9 2-10 2-11 2-12 2-13 2-14 2-15 2-16 2-17 2-18 2-19 2-20 2-21 2-22 2-23 2-24 2-25 2-26 3-1 3-2 3-3 3-4 3-5 3-6 3-7 3-8 3-9 [. . . ] Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. [. . . ]