ユーザーズガイド CAMPINGAZ WOODY ADVANTAGE

[. . . ] Operation is subject to the following two conditions: • • This device may not cause harmful interference, and This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Operation is subject to the following two conditions: • • This device may not cause harmful interference, and This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with manufacturer’s instructions, may cause harmful interference to radio communications. • Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This class B digital apparatus complies with Canadian ICES-003. v vi vii viii ix x 1 2 3 4 5 31 30 29 28 27 26 25 24 23 22 21 20 6 7 8 9 10 11 12 13 19 18 17 34 16 15 14 35 36 37 38 32 33 45 44 43 42 41 40 39 24. 5cm (9. 64in) T: Mouse B: Keyboard PS/2 KBPWR1 Socket 462 DDR DIMM1 (64/72 bit, 184-pin module) DDR DIMM2 (64/72 bit, 184-pin module) CPU_FAN1 Bottom: USBPWR_34 COM1 DDR DIMM3 (64/72 bit, 184-pin module) USB3 RJ-45 USB4 Top: PARALLEL PORT CNTR/ LFE1 SURR1 USBPWR_12 SPDIFOUT2 Bottom: Top:Line In Center:Line Out Below:Mic In ACL101L 0 1 2 3 4 5 SEC_IDE1 PWR_FAN1 Realtek RTL8201 CHA_FAN1 Accelerated Graphics Port (AGP Pro) AGP_WARN1 CD1 FPAUDIO1 4Mb BIOS PCI 1 AUX1 nForce2 MCP-T/MCP Audio Codec Chipset SPDIF1 IEEE1394_1 PCI 2 ® Super I/O IEEE1394_2 A7N8X CR2032 3V Lithium Cell CMOS Power SATA_EN1 CLRTC1 COM2 USB56 PCI 3 PCI 4 PWR_LED1 Realtek RTL8801 USBPWR_56 GAME1 MODEM1 Speech Controller SATALInk Chipset PCI 5 with Hardware Monitor PWRTMP1 CAMPINGAZ ASIC IR_CON1 SMB1 IDELED1 CTRL_PANEL1 SEC_SATA1 PRI_SATA1 CHASSIS1 BUZZ1 PRI_IDE1 30. 5cm (12. 0in) USB1 RJ-45 USB2 Top: CPU_FSB nForce2 SPP (Ultra400) Chipset FLOPPY1 nVidia ATX Power Connector WARNING ON Incorrect AGP Card OFF Correct AGP Card PWR_LED ® A7N8X A7N8X Onboard LED ON Standby Power OFF Powered Off CPU NOTCH TO INNER CORNER LOCK LEVER ® A7N8X AMD™ CPU CPU NOTCH A7N8X Socket 462 104 Pins ® A7N8X 80 Pins A7N8X 184-Pin DDR DIMM Sockets • AGP Card without Retention Notch ® A7N8X TOP VIEW 20-pin bay Rib (inside slot) 28-pin bay Rib A7N8X Accelerated Graphics Port (AGP PRO) SATA_EN1 1 2 ® 2 3 Disable (Default) A7N8X Enable (Default) A7N8X SATA Setting KBPWR1 1 2 +5V (Default) ® 2 3 +5VSB A7N8X A7N8X Keyboard Power Setting USBPWR_12 USBPWR_34 1 2 +5V (Default) 2 3 +5VSB USBPWR_56 ® A7N8X 1 2 +5V (Default) 2 3 +5VSB A7N8X USB Device Wake Up CLRTC1 1 2 ® 2 3 Clear CMOS A7N8X Normal (Default) A7N8X Clear RTC RAM CPU_FSB 1 2 ® 2 3 FSB200 A7N8X FSB400/333/266 (Default) A7N8X CPU FSB Jumper Setting PS/2 Mouse (6-pin Female) PS/2 Keyboard (6-pin Female) USB 4 USB 2 USB3 Universal Serial Bus USB1 COM1 Serial Ports (9-pin Male) COM2 PIN 1 ® A7N8X A7N8X Serial COM2 Bracket RJ-45 RJ-45 Parallel Port (25-pin Female) In Out Mic S/PDIF Connector Line in Front Speaker Left/Right Microphone Center/Speaker Bass Speaker Surround Speaker Left/Right IDELED1 ® A7N8X TIP: If the case-mounted LED does not light, try reversing the 2-pin plug. A7N8X IDE Activity LED FLOPPY1 NOTE: Orient the red markings on the floppy ribbon cable to PIN 1 ® A7N8X PIN 1 A7N8X Floppy Disk Drive Connector SEC_IDE1 ® A7N8X PIN 1 A7N8X IDE Connectors PRI_IDE1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. SEC_SATA1 ® PRI_SATA1 GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXP1 RSATA_RXN1 GND A7N8X A7N8X SATA Connectors IR_CON1 +5 V IRRX GND IRTX GND RSATA_TXP2 RSATA_TXN2 GND RSATA_RXP2 RSATA_RXN2 GND Standard Infrared (SIR) Front View Back View SIR CIR NC GND NC CIRRX +5VSB ® A7N8X IRTX GND IRRX +5V (NC) A7N8X Infrared Connector CPU_FAN1 Rotation +12V GND PWR_FAN1 CHA_FAN1 GND +12V Rotation ® A7N8X A7N8X 12-Volt Cooling Fan Power IEEE1394_2 ® A7N8X A7N8X 1394 Headers Ground Ground TPA2+ TPA2TPB2+ TPB2Ground +12V Ground Ground TPA2+ TPA2TPB2+ TPB2Ground +12V GND +12V Rotation IEEE1394_1 ATXPWR1 +3. 3VDC -12. 0VDC COM PS_ON# COM COM COM -5. 0VDC +5. 0VDC +5. 0VDC +3. 3VDC +3. 3VDC COM +5. 0VDC COM +5. 0VDC COM PWR_OK +5VSB +12. 0VDC ® A7N8X A7N8X ATX Power Connector SMB1 ® A7N8X 1 FLOATING SMBCLK A7N8X SMBus Connector Ground SMBDATA +3V ® A7N8X ® A7N8X A7N8X Internal Audio Connectors A7N8X Digital Audio Connector GND GND SPDIF1 SPDIF_IN MODEM1 +5V Modem-In Ground Ground Modem-Out SPDIF_OUT 1 Right Audio Channel Ground Left Audio Channel CD1 (Black) Left Audio Channel Ground Right Audio Channel AUX1 (White) ® A7N8X USB56 A7N8X USB 2. 0 Header USB+5V USB_P5USB_P5+ GND 1 PWRTMP1 ® A7N8X PWRTMP A7N8X Power Supply Thermal Connector USB+5V USB_P6USB_P6+ GND NC Ground A7N8X Game Connector ® ® A7N8X A7N8X A7N8X Chassis Open Alarm Lead GAME1 CHASSIS1 1 +5Volt (Power Supply Stand By) Chassis Signal Ground MIDI_IN J2B2 J2CY MIDI_OUT J2CX J2B1 +5V +5V J1B2 J1CY GND GND J1CX J1B1 +5V FPAUDIO1 AGND +5VA BLINE_OUT_R ® A7N8X A7N8X Front Panel Audio Connector MIC2 MICPWR Line out_R NC Line out_L Keyboard Lock Power LED PLEDKeylock Ground PLED+ BLINE_OUT_L Speaker Connector +5V Ground Ground Speaker ExtSMI# Ground PWR GND ® A7N8X Reset SW SMI Lead ATX Power Switch* A7N8X System Panel Connectors * Requires an ATX power supply. Reset Ground \ \ \ \ \ \ \ \ \ \ \ \ \ CPU Cooling System Setup \ \ Create RAID Set Delete RAID Set Rebuild RAID Set Resolve Conflicts ↑↓ ESC Enter Ctrl-E Select Menu Previous Menu Select Exit chunk [. . . ] Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. [. . . ]