ユーザーズガイド DENON SC-A50

[. . . ] Do not apply inputs exceeding the speaker system's max. input (the input which can be applied a short period of time with regular program sources). The output terminals may differ depending on the amplifier being used. Consult the amplifier's instructions. Clipping or other problems may occur in the output waveform when using the speaker systems with a high output and the amplifier's tone controls set to the maximum. [. . . ] If this happens, turn off the TV's power, wait 15 to 30 minutes, and turn the power back on. The TV's self demagnetizing circuit will improve the picture. If the colors are still blotchy, move the speaker systems further away from the TV. Also note that if there is a magnet or any device generating magnetic force nearby, interaction between this device and the speaker systems can cause the colors on the TV to become blotchy. Please stick the feet at bottom of the cabinet as below to prevent slipping. Large screws holes with 120 mm interval at bottom are dedicated for optional bracket ASG-555. (See a diagram below. ) Use in case of ceiling or wall installing. [Bottom view] Feet Feet Large screws holes for bracket ASG-555 REMOVING THE SPEAKER NET The net on the front of the speaker system is detachable. To remove it, grasp it on both sides and pull it towards you. To attach the net, line up the plastic pieces holes out of the net with the sticking in the cabinet and press in. CONNECTIONS Before connecting, please consult with the instructions of your amplifier and follow them also. Be sure to turn the amplifier's power off when connecting the speaker systems. Use the included cables to connect the input terminals on the back of the speaker systems (see diagram) to the amplifier's speaker output terminals. Connect the speaker system for the left channel amplifier's "L" terminals, the one for the right channel to the amplifier's "R" terminals, matching the polarities (" <" and ">" marks). Inverting the polarities will result in unnatural sound, with the phase off or no low bass sound. Please do not remove the short-circuit plate provided at this time. Also check that all four terminal knobs are tightly fastened. Connections (The red terminals on the right side are the "<" terminals, the black ones on the left side the ">" terminals. ) • For normal use Loosen the terminal knobs and insert the short-circuit plates. Loosen the terminal knobs, insert the cords' core wires, then tighten the konobs. Connect to amplifier's "<" side. (Copper color) Short-circuit plate Red terminal < Black terminal Connect to amplifier's ">" side. (Silver color) NOTE: Make sure the core wires do not touch each other. [. . . ] The overall impedance of these speaker systems is 6 ohms, so bi-wiring is possible as long as your amplifier's applicable load impedance is 6 ohms or less. Connections for Bi-wiring NOTE: Be sure to remove the short-circuit plates first. • For amplifiers with no "A+B" posision Tweeter / Super tweeter Connect to amplifier's "<" side. (Copper color) Short-circuit plate < Woofer terminals * Tighten the knobs securely. Connect to amplifier's ">" side. [. . . ]