ユーザーズガイド DENON SC-E717R

[. . . ] input (the input which can be applied a short period of time with regular program sources). The output terminals may differ depending on the amplifier being used. Consult the amplifier's instructions. [. . . ] The responsibility for damage or accident due to falling speakers will not be borne by Denon. This is an anti-magnet type speaker system which can be used near television sets, etc. , but with some TV sets the colors may become blotchy. If this happens, turn off the TV's power, wait 15 to 30 minutes, and turn the power back on. The TV's self demagnetizing circuit will improve the picture. If the colors are still blotchy, move the speaker systems further away from the TV. Also note that if there is a magnet or any device generating magnetic force nearby, interaction between this device and the speaker systems can cause the colors on the TV to become blotchy. Insulators are attached as accessories to these speaker systems. Keep these speaker systems over these insulators if you like. (3 insulators should be used for one speaker system. ) REMOVING THE SPEAKER NET The net on the front of the speaker system is detachable. To remove it, grasp it on both sides and pull it towards you. To attach the net, line up the plastic pieces sticking out of the net with the holes in the cabinet and press in. < > < < > > < > < <> < > < > > CONNECTIONS Be sure to turn the amplifier's power off when connecting the speaker systems. Connections (The red terminals on the right side are the "<" terminals, the black ones on the left side the ">" terminals. ) Normal Connections Use the included cables to connect the input terminals on the back of the speaker systems (see diagram) to the amplifier's speaker output terminals. Connect the speaker system for the left channel amplifier's "L" terminals, the one for the right channel to the amplifier's "R" terminals, matching the polarities ("<" and ">" marks). Inverting the polarities will result in unnatural sound, with the phase off or no low bass sound. Also check that all four terminal knobs are tightly fastened. For normal use Confirm the short-circuit plates are set. Loosen the terminal knobs, insert the cables' core wires, then tighten the knobs. Short-circuit plate Connect to amplifier's "<" side. Red terminal Black terminal Connect to amplifier's ">" side. NOTE : Make sure the core wires do not touch each other. Bi-wiring Connections These speaker systems are equipped with input terminals allowing bi-wiring, so four speaker cables can be used for even greater sound. (A network circuit is included, so there is no need for a channel divider. ) First prepare four speaker cables, two each for the left and right channels. The top set of input terminals are for the tweeter the bottom set for the woofer. First loosen all the knobs, remove both short-circuit plates, then connect the speaker cables to the respective terminals. [. . . ] Connections for Bi-wiring For amplifiers with no "A+B" position For amplifiers with an "A+B(parallel)" or with "A+B(series)" position position Tweeter terminals Connect to amplifier's "<" side. Remove short-circuit plates Woofer terminals Connect to amplifier's ">" side. Tweeter terminals Be sure that the "<" and " > " sides are properly interconnected. [. . . ]