ユーザーズガイド DENON SC-F101

[. . . ] B SPEAKER SYSTEM SC-F101 Read this manual carefully to ensure that you take full advantage of all this unit has to offer. Keep the manual for future reference should any doubts or problems arise. Please make sure that the following items are included with the main unit in the carton. [. . . ] The output terminals may differ depending on the amplifer being used. Consult the amplifier's instructions. Clipping or other problems may occur in the output waveform when using the speaker systems with a high output and the amplifier's tone controls set to the maximum. Avoid using them under these conditions. Never play such special signals as a tape recorder's fastforwarding signals or sine waves continuously. When moving the speaker systems, be careful not to apply excess force to the speaker nets. Doing so could damage the speaker units. INSTALLATION Please install the speakers at the SAFE PLACE, in the SAFE WAY! In case using stands available in a market, please follow the instructions of them and confirm them being safe enough. DENON do not take any responsibility for any accident caused by unsteady installing. The tone character produced by speaker systems depends on such factors as the size and type of room, the method of installation, etc. Pay attention to the following points when installing the speaker systems. If the bass sound is overemphasized when the speaker systems are installed directly on the floor, set them on concrete blocks or other hard stands. Note that howling may be produced if the speaker systems are placed on the same stand or shelf as a record player. If there are walls or glass doors behind or in front of the speaker systems, use heavy curtains, etc. , to prevent resonance and reflection. This is an anti-magnet type speaker system which can be used near television sets, etc. , but with some TV sets the colors may become blotchy. If this happens, turn off the TV's power, wait 15 to 30 minutes, and turn the power back on. The TV's self demagnetizing circuit will improve the picture. [. . . ] Also check that all two terminal knobs are tightly fastened. Connections (The red terminals on the right side are the "<" terminals, the black ones on the left side the ">" terminals. ) Loosen the terminal knobs, insert the cables' core wires, then tighten the knobs. < Connect to amplifier's "<" side. (Copper color) > NOTE : Make sure the core wires do not touch each other. Connect to amplifier's ">" side. (Silver color) Effective only in Japan z c x v b 16-11, YUSHIMA 3-CHOME, BUNKYOU-KU, TOKYO 113-0034, JAPAN Telephone: (03) 3837-5321 [. . . ]