ユーザーズガイド PANASONIC NV-AL30

[. . . ] 1 ª ª ; ª ≥ 3 ª 4 ª ª ≥ ≥ ª ≥ ≥ ≥ ª 5 A ; ; ; ZOOM A A CINEMA WIDE LOWCUT AUTO MNL a & AWB 12bit a1 1 ; 5 6 1760 æ 1760 1280 640 QXGA UXGA SXGA XGA SVGA 640 1760 1280 640 5 Y ≥ ≥ & Y 0 3 3 1 ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ 2 & ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ 2 & ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ 2 & ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ A A RESET ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ 3 ≥ ≥ ≥ ≥ ≥ ≥ ª ≥ A ª B ≥ 4 ª ª ≥ ≥ ≥ ≥ ≥ ª ≥ ≥ ≥ ª ≥ ≥ ≥ ≥ ∫ ∫ + - ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ + - ¥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ≥ ™ ≥ ™ ™ ™ ≥ ™ ™ ™ ≥ ≥ ≥ ≥ ≥ ≥ ª 256 ≥ ≥ Quick guide (English) Power supply ∫Charging the battery When this product is purchased, the battery is not charged. Charge the battery before using this product. ≥ If the DC input lead is connected to the AC adaptor, then the battery will not get charged. [. . . ] ≥ If the DC input lead is connected to the AC adaptor, then the battery will not get charged. Remove the DC input lead from the AC adaptor. ∫Fitting the battery Push the battery (or the DC input lead) against the battery holder and slide it until it clicks. the AC mains lead to the 1 Connect AC adaptor and the AC mains socket. the battery on the battery 2 Put mount by aligning the mark, and then securely plug it in. ∫Removing the battery While sliding the [BATT] lever, slide the battery (or the DC input lead) to remove it. BATT ∫Charging lamp Lights up:Charging Goes off: Charging completed Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up and normal charging will start. When the battery temperature is excessively high or low, the [CHARGE] lamp flashes and the charging time will be longer than normal. ≥ Hold the battery with your hand so it does not fall. Inserting/removing a cassette the [ 1 Slide (OPEN/EJECT) lever and open the cassette cover. ] Inserting/removing a card Before inserting/removing a card, be sure to turn the power [ ] (OFF). ≥ If the card is inserted or removed with the power turned on, this camera may malfunction or the data recorded on the card may be lost. the LCD monitor and then 1 Open open the card slot cover. ≥When the cover is fully opened, the cassette holder will come out. the cassette holder is 2 After opened, insert/remove the cassette. the card into/from 2 Insert/remove the card slot. ≥When inserting a cassette, orient it as shown in the figure, and then securely insert it as far as it goes. ] (MENU) the joystick up or down in 6 Move order to select the item to be set. ≥The menu corresponding to the mode selected by the mode dial is displayed. ≥Do not switch the mode dial when the menu is displayed. the joystick to determine 7 Press the setting. the joystick up or down in 2 Move order to select the top menu. ∫To get back to the previous screen Move the joystick left. the joystick right or press it 3 Move to set the selection. ∫To exit the menu screen Press the [ ] (MENU) button. the joystick up or down in 4 Move order to select the sub-menu. Switching the language You can switch the language on the screen display or the menu screen. Set [ LANGUAGE] >> [ENGLISH]. the joystick right or press it 5 Move to set the selection. Recording on a tape ≥ Set to Tape Recording Mode. PC Recording still pictures onto a card (Photoshot) ≥ Set to Card Recording Mode. PC the recording start/stop 1 Press button to start recording. the [ ] 1 Press (PHOTO SHOT) button halfway in order to adjust focusing. (For auto focusing only) ≥The iris/gain value is fixed and this the recording start/stop 2 Press button again to pause recording. camera focuses on the subject automatically. Recording still pictures on a card while recording image onto a tape 1Shutter chance mark You can record still pictures while recording image onto a tape. ≥ Set to Tape Recording Mode. 1 2 ± (The white lamp flashes. ): Focusing ¥ (The green lamp lights up. ): When in focus No mark: When focusing is unsuccessful Press the [ ] (PHOTO SHOT) button fully while recording image onto a tape. ≥The shutter chance mark is indicated as follows when the [ ] (PHOTO SHOT) button is not pressed halfway. ¥ (The green lamp lights up. ): When in focus and a good picture can be recorded ± (The White lamp lights up. ): Almost in focus 2Focus area the [ ] 2 Press (PHOTO SHOT) button fully. Quick guide (English) (Continued) Zoom in/out function You can zoom in up to 10koptically. ≥ Set to Tape/Card Recording Mode. Playing back tape ≥ Set to Tape Playback Mode. PC Wide-angle recording (zoom out): Push the [W/T] lever towards [W]. Close-up recording (zoom in): Push the [W/T] lever towards [T]. Operate with joystick. : Playback/Pause 6: Rewind/Review playback (Reverts to playback with the to playback with the ∫: Stop icon. ) icon. ) 5: Fast forward/Cue playback (Reverts ∫To adjust volume Adjust the speaker or headphone volume for playback. Move the [s / (VOLUME) r] lever to adjust the volume. W T Towards [r]: increases the volume Towards [s]: decreases the volume (Nearer the bar to [r], larger the volume. ) Playback on TV Images recorded by this camera can be played back on a TV. ≥ Insert a recorded tape into this camera. Playing back card ≥ Set to Picture Playback Mode. PC 1 Connect the movie camera and a TV. AV/ Operate with joystick. 1 S-VIDEO 2 : Slide show (Plays back the still pictures on the card in order) start/ stop. D : Plays back the next picture. ≥Connect the movie camera and a TV by ≥If the TV has an S-Video terminal, then also connect an S-Video cable 2 (optional). [. . . ] Close-up recording (zoom in): Push the [W/T] lever towards [T]. Operate with joystick. : Playback/Pause 6: Rewind/Review playback (Reverts to playback with the to playback with the ∫: Stop icon. ) icon. ) 5: Fast forward/Cue playback (Reverts ∫To adjust volume Adjust the speaker or headphone volume for playback. Move the [s / (VOLUME) r] lever to adjust the volume. W T Towards [r]: increases the volume Towards [s]: decreases the volume (Nearer the bar to [r], larger the volume. ) Playback on TV Images recorded by this camera can be played back on a TV. ≥ Insert a recorded tape into this camera. Playing back card ≥ Set to Picture Playback Mode. PC 1 Connect the movie camera and a TV. AV/ Operate with joystick. 1 S-VIDEO 2 : Slide show (Plays back the still pictures on the card in order) start/ stop. D : Plays back the next picture. ≥Connect the movie camera and a TV by ≥If the TV has an S-Video terminal, then also connect an S-Video cable 2 (optional). [. . . ]