ユーザーズガイド PHILIPS AT752

[. . . ] Keep the appliance out of the reach of children. Do not let the mains cord hang over the edge of the table or worktop on which the appliance is standing. This appliance is intended for household use only. If the appliance is used improperly or for professional or semiprofessional purposes or if it is used in a way that is not in accordance with the instructions for use, the guarantee will become invalid and Philips will not accept liability for any damage caused. ENGLISH ◗ ◗ ◗ ◗ ◗ ◗ 7 Place the rice cooker on a stable, horizontal and level surface. [. . . ] Check if the inner pot is in proper contact with the heating element (fig. Make sure that the outside of the inner pot is dry and clean and that there is no foreign residue on the heating element or the magnetic switch. 7 Close the lid of the rice cooker, put the plug in the wall socket and switch on the mains. ◗ AT752/HD4723:The cook light goes on to indicate that the appliance is on (fig. 8). 8 ENGLISH 8 HD4738/HD4733: Set the function selection switch to RICE (fig. ◗ HD4738/HD4733:The rice light goes on (fig. 9 Press the control lever down to start the cooking process (fig. If you fail to press down the control lever, the rice cooker will automatically switch to the keepwarm mode. The cook light/rice light goes out and the warm light goes on. ◗ When the cooking process is finished, the cook light/rice light goes out and the warm light goes on to indicate that the rice cooker has automatically switched to the keep-warm mode (fig. 12). 10 Open the lid and stir the rice to loosen it (fig. For the best results, do this just after the rice cooker has switched to keep-warm mode. Then close the lid firmly. When the rice cooking process is finished, the rice cooker automatically switches to the keep-warm mode. The cook light/rice light goes out and the keep-warm light goes on. We advise you to keep rice warm for not more than 12 hours so as to preserve its taste. The cook light/rice light may go on occasionally to indicate that the temperature inside the rice cooker has become too low and the heating element has switched on to heat up the rice cooker to the right keep-warm temperature. To end the keep-warm function, pull up the control lever, switch off the mains and remove the mains plug from the wall socket. The congee function does not have a keep warm mode. Cleaning Unplug the rice cooker before you start cleaning it. Wait until the rice cooker has cooled down sufficiently before cleaning it. To protect the non-stick coating of the inner pot, do not: - use the inner pot for washing dishes; - put vinegar in the pot. 1 Take the steam tray and the inner pot out of the body of the appliance. 2 Detach the steam vent cap from the outer lid by pulling it upwards (fig. 3 To take the steam vent cap apart, twist and turn to unlock (fig. [. . . ] The warm light does not go on when the cooking process is finished. The light is defective. HD4738/4733:You have set the function selection switch to CONGEE. At the end of the congee cooking process, the rice cooker does not switch to the keep-warm mode. Add water according to the scale on the inside of the inner pot (see chapter 'Using the appliance'). [. . . ]