ユーザーズガイド PHILIPS PT 725

[. . . ] Caution - Never immerse the shaver in water. - Do not use the shaver in the bath or in the shower. - Never use water hotter than 80°C to rinse the shaver. Always check if the water is not too hot, to prevent your hands from getting burnt. [. . . ] 1 Press the on/off button once to switch on the shaver. 2 Push the trimmer slide downwards to open the trimmer. , You can now start trimming. 3 After trimming, close the trimmer and switch off the shaver. 23 EnGlIsh 11 Cleaning and maintenance Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance. - Clean the shaver after every shave for optimal shaving performance. - Regular cleaning guarantees better shaving performance. Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the shaver when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. Cleaning the shaving unit under the tap 1 Switch off the shaver and disconnect it from the mains. 2 Press the release button to open the shaving unit. 3 Rinse the shaving unit and hair chamber under a hot tap for 30 seconds. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. - Rinse the hair chamber and the inside of the shaving unit. 24 12 EnGlIsh - Rinse the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Be careful not to hit the shaving unit against anything while shaking off excess water. Never dry the shaving unit and the hair chamber with a towel or tissue, as this may damage the shaving heads and the coupling spindles. 5 Open the shaving unit again and leave it open to let the shaver dry completely. Cleaning the shaving unit with the cleaning brush 1 Switch off the shaver and disconnect it from the mains. 2 Press the release button to open the shaving unit. 3 Pull the shaving unit off the shaver. 2 1 4 Turn the lock anticlockwise (1) and remove the retaining frame (2). 25 EnGlIsh 13 5 Remove and clean one shaving head at a time. Each shaving head consists of a cutter and a guard. Note: Do not clean more than one cutter and guard at a time, since they are all matching sets. If you accidentally mix up the cutters and guards, it may take several weeks before optimal shaving performance is restored. - Remove the cutter from the shaving guard and clean it with the brush. - Clean the inside and outside of the shaving guard with the brush.  Put the shaving heads back into the shaving unit. PT0/PT35/PT30: Make sure that the projections of the shaving heads fit exactly into the recesses.  Put the retaining frame back into the shaving unit and turn the lock clockwise. 26 English 8 Insert the lug of the shaving unit into the slot in the top of the shaver (1). Then close the shaving unit (2). Note: If the shaving unit does not close smoothly, check if you have inserted the shaving heads properly and if the retaining frame is locked. Cleaning the trimmer with the cleaning brush (PT860 only) Clean the trimmer every time you have used it. 1 Switch off the shaver and disconnect it from the mains. 2 Push the trimmer slide downwards to open the trimmer. [. . . ] Recharge the battery (see chapter ‘Charging’) or connect the shaver to the mains. As soon as the temperature of the shaver has dropped sufficiently, you can switch on the shaver again. You have not inserted the shaving heads properly. The shaver does not work when I press the on/off button. The temperature of the shaver is too high. [. . . ]