ユーザーズガイド PHILIPS QC 5380

[. . . ] Use, charge and store the appliance at a temperature between 15°C and 35°C. Only use the adapter supplied to charge the appliance. If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. [. . . ] The settings in the window show the selected hair length in millimetres after cutting. e Tip:Write down the hair length settings you selected to create a certain hairstyle as a reminder for future clipping sessions. 4 Press the on/off button to switch on the appliance (Fig. 6). s 5 Move the appliance through the hair slowly. - m - Tips To clip most effectively, move the appliance against the hair growth direction. Since all hair does not grow in the same direction, you need to move the appliance in different directions (upwards, downwards and across). Make sure that the flat part of the comb is always fully in contact with the scalp to obtain an even result (Fig. 7). 28 QC5380_CS2_EN_A6resize. indd 28 12. 6. 22 9:07:44 PM EnGlIsh Make overlapping passes over the head to ensure that you cut all the hair that needs to be cut. N fo se 6 Regularly remove cut hair from the comb. If a lot of hair has accumulated in the comb, remove the comb from the appliance and blow and/or shake the hair out of it. 4 Contouring without comb You can use the appliance without comb to trim hair very close to the skin (0. 5mm) or to contour the neckline and the area around the ears. Be careful when you clip without comb because the cutting element removes every hair it touches. 1 Press the setting selector and slide the comb O to 5 M th up, to remove the comb off the appliance. 2 Before you start to contour the hairline Yo cu around the ears, comb the hair ends over the ears. 6) 1 2 3 Press the on/off button to switch on the W fu 29 QC5380_CS2_EN_A6resize. indd 29 12. 6. 22 9:07:45 PM EnGlIsh Note: During trimming, you can use the turbo function for extra suction power and trimming speed (see section ‘Turbo function’ below). 4 Tilt the appliance in such a way that only one edge of the cutting element touches the hair ends when you shape the contours around the ears. The hairline should be close to the ear. 5 To contour the neckline and sideburns, turn the appliance and make downward strokes (Fig. Turbo function You can use the turbo function to increase the cutting speed. 1 Switch on the appliance. 9) b e When you switch off the appliance, the turbo function is deactivated automatically. 30 QC5380_CS2_EN_A6resize. indd 30 12. 6. 22 9:07:45 PM EnGlIsh Cleaning Clean the appliance every time you have used it with the cleaning brush and with warm water (max. Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol, acetone or ethereal oils to clean the appliance. Note:The appliance does not need any lubrication. 1 Switch off the appliance and disconnect it 6 from the mains. 2 Remove the comb from the appliance and rinse it under the tap. brush supplied. If w ha O o P ha d If p C p - 3 Brush the outside of the shaving unit with the 4 Push the centre top end of the cutting element upwards with your thumb until it opens (Fig. [. . . ] philips. com/support or contact the Philips Consumer Care Centre in your country. You find its phone number in the worldwide guarantee leaflet. If there is no Consumer Care Centre in your country, go to your local Philips dealer. [. . . ]