ユーザーズガイド PHILIPS QT 4015

[. . . ] Important Read this user manual carefully before you use the appliance and save it for future reference. Danger - Make sure the adapter does not get wet. Warning - The adapter contains a transformer. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. 19 EnGlIsh - This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Do not use thick shaving cream or shaving oil with this shaver. - For optimal shaving results, make circular movements during use. - The shaver is waterproof and can be used in the bath or shower. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Wet shaving 1 Apply some water to your skin. 2 Apply shaving foam or shaving gel to your skin. 3 Rinse the shaving unit under the tap to ensure that the shaving unit glides smoothly over your skin. 23 EnGlIsh 4 Press the on/off button once to switch on the shaver. 5 Move the shaving heads in circular movements over your skin. Note: Rinse the shaver under the tap regularly to ensure that it continues to glide smoothly over your skin. 6 After shaving, press the on/off button once to switch off the shaver and dry your face. 7 Clean the shaver (see chapter ‘Cleaning and maintenance’). Note: Make sure you rinse all foam or shaving gel off the shaver. Dry shaving 1 Press the on/off button once to switch on the shaver. 2 Move the shaving heads in circular movements over your skin. 3 After shaving, press the on/off button once to switch off the shaver. 8 Insert the lug of the shaving unit into the slot in the top of the shaver (1). Then close the shaving unit (2). Note: If the shaving unit does not close smoothly, check if you have inserted the shaving heads properly and if the retaining frame is locked. Cleaning the trimmer with the cleaning brush (AT891/AT890) Clean the trimmer every time you have used it. 1 Switch off the shaver and disconnect it from the mains. 2 Push the trimmer slide downwards to open the trimmer. 3 Clean the trimmer with the short-bristled side of the cleaning brush. Brush up and down along the trimmer teeth. 4 Close the trimmer (‘ click’). 28 1 2 EnGlIsh Tip: For optimal trimming performance, lubricate the trimmer teeth with a drop of sewing machine oil every six months. storage - Put the protection cap on the shaver to prevent damage. - AT891 only: Store the shaver in the pouch supplied. Replacement For maximum shaving performance, we advise you to replace the shaving heads every two years. Replace damaged shaving heads right away. Only replace the shaving heads with original HQ8 Philips Shaving Heads. 1 Disconnect the shaver from the mains. [. . . ] The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way. Removing the rechargeable shaver battery Only remove the rechargeable battery when you discard the shaver. Make sure the rechargeable battery is completely empty when you remove it. 1 Disconnect the shaver from the mains. 2 Let the shaver run until it stops. [. . . ]