ユーザーズガイド ROLAND GK-KIT-GT

[. . . ] When handling the board, grasp it only by its edges. Avoid touching any of the electronic components or connectors. Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly. [. . . ] • Protect the unit from strong impact. (Do not drop it!) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 013 004 To properly drive the [GR] with the GK-KIT-GT, you must adjust the height of the Divided Pickup and the sensitivity of the [GR]. These adjustments are very important if you want to take full advantage of the [GR]’s superior tracking ability. Please read the GK-KITGT and [GR] owner ’s manuals. Installation • Even when properly installed, the GK-KIT-GT will not work with 12-string guitars, guitars with unusual or customized string setups, nylon-string guitars, gutstring guitars, or bass guitars. • If your guitar has a tremolo arm (whammy bar), attach the arm before setting up the GK-KIT-GT. • Adjust the neck (truss rod) and the height of the strings if necessary before installing the GK-KIT-GT. • Try placing the Divided Pickup on the guitar to see if they are compatible before actually attaching them. • If there is no room for the Divided Pickup between the guitar ’s bridge pickup and the bridge itself, you would be better off modifying your guitar. (If possible, move the bridge pickup closer to the neck to make room for the Divided Pickup). C-13A/B cable Be sure to use the C-13A/B cable to connect the GK-KITGT to the [GR]. Using any other cable may cause unnecessary problems. The C-13A/B is a locking-type cable which cannot be disconnected unless it is unlocked. Before playing, be sure to wrap the cable around the guitar strap near the strap hook. This will eliminate any unnecessary strain on the cable or the GK-KIT-GT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 3. Solder the white wire to the guitar signals. uncovered ➔ earth (ground) of the guitar small connection port 170±10 white ➔ guitar signal 150±5 FOR SWITCH, LED WIRING (SELECT SWITCH, DOWN/S1SWITCH, UP/S2 SWITCH, LED) 1. Ground wire for each wiring is common. [. . . ]