ユーザーズガイド ROLAND MPU-401

[. . . ] To move the piano, lift it carefully-all the while keeping it level. Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your hands or feet. [. . . ] Should you remove screws, cord clamps, or stabilizer, make sure to put them in a safe place out of children’s reach, so there is no chance of them being swallowed accidentally. When placing the pedal board onto the metal fixtures, take care not to scratch the side boards. fig. st5. e 8. Putting the Pedal Board (a lateral view) Pedal Board Connect the speaker cable extending from the rear of the speaker box to the DP-990’s speaker connector. Press the speaker cable completely into the connector so that it is securely fastened. DP-990 Rear fig. st8. e Speaker Connecter Clip Portion Ferrite Core ■ Check the Parts Before you begin assembling the DP-990, check that all the parts were supplied. You will also need to have a Phillips screwdriver. • The packing sheets that are wrapped around the side boards should not be removed until after you've completed step 4. These sheets have been placed on the boards in the interest of preventing them from being scratched during the assembly process. Side board (left) DP-990 1. Secure the right side board to the speaker box with the attachment screws (M6 x 20 mm, in two places). Attach so that the speaker cable at the rear of the speaker box is directed to the left. Side board right Front Speaker box Pedal Board Extend the pedal cable Speaker cable Metal Fixtures Hold and insert the cable so that the clip portion extends into the stand and is securely connected. 5. R Rear Secure the Pedal Board to the side boards with the attachment screws (M6 x 20 mm, in two places). Remove the packing sheet from each side board. fig. st6. e * Use the speaker cable with the ferrite core left attached to the cable. Having the speaker box face out the rear of the instrument allows the speakers to be directed toward listeners when the back of the instrument faces the audience. fig. stsp. e * Pedal Cable Normal direction Front Rear When facing to the rear Front Rear Right Left Please don’t get your fingers pinched When Moving the Instrument 7 6 Attachment Screw Stabilizer screws Rear Front Speaker box Speaker box Take care not to attach the left and right stabilizer to the wrong sides. Place the pedal board onto the metal fixtures. Temporarily loosen the screws you installed in steps 1 and 2, and spread the left and right side boards apart. Rear Loosen the screws (in four places). Disconnect the power cord and cables from the DP-990. Then lift the piano while keeping it level, and move it with care, so that you do not drop it on your feet, or get your hands caught. Check the stability of the pedal, and make adjustments as necessary. ■ Assembly Procedure • Be sure to insert the attachment screws by hand, and turn them several times by hand before using a screwdriver to tighten them. At first, assemble the entire unit in a temporary fashion, without really tightening the screws. Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. [. . . ] Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. Be careful when assembling the DP-990, so as to avoid scratching the parts. [. . . ]