ユーザーズガイド ROLAND SN-R8-06

[. . . ] To quit without making the settings, use the SELECT dial to choose “NO, ” then press the ENTER button. Once the settings have been successfully modified, you’re returned to the setting item selection screen. This ends the setting process and returns you to the usual screen. [. . . ] * While making the settings, you can go back to the previous entry location (highlighted) by pressing the PAUSE (BACK) button. * If you press the MODE button while making settings, a message asking you to confirm that you want to exit the setting process appears. Note that if you choose “YES, ” then press the ENTER button, you are returned to the usual screen, and all setting changes you’ve made up to that point will be discarded. Added Features • • An item for Crossfade Time has been added to “1. 5 Loop Play. ” An item for Offset has been added to “6. 9 MTC. ” The MODE indicator lights up. Use the SELECT dial to choose “1. 5 Loop Play, ” then press the dial. You can reselect a phrase whose setting you want to change by pressing the PAUSE (BACK) button. The entry position (highlighted) moves to the phrase selection, so turn the SELECT dial to reselect card A or B and the phrase number, then press the dial. Turn the SELECT dial to choose Loop (OFF/ON/1 to 99), then press the dial. fig. 11-g05e Procedure for Setting the MTC Offset 1. * Each press of the BACK button moves the cursor (highlighted) in the sequence of sf → f → s → m → h. Turn the SELECT dial to set the Loop 2 position (time), then press the dial. * The looped region cannot be set to value less than 10 frames. Each press of the BACK button moves the cursor (highlighted) in the sequence of f → s → m → h. If a start or end playback point is set within the looped interval, the start point is set to Loop 1 and the end point is set to Loop 2. 5. When the prompt appears on the screen, press the ENTER button to enable the settings. To quit without making the settings, use the SELECT dial to choose “NO, ” then press the ENTER button. Once the settings have been successfully modified, you’re returned to the setting item selection screen. This ends the setting process and returns you to the usual screen. [. . . ] Once the settings have been successfully modified, you’re returned to the setting item selection screen. This ends the setting process and returns you to the usual screen. * While making the settings, you can go back to the previous entry location (highlighted) by pressing the PAUSE (BACK) button. [. . . ]