ユーザーズガイド RYOBI BD1020CVR SCHEMA

[. . . ] Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with manufacturer’s instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Option CPU Frequency PCI Express Clock DDR Voltage CPU Multiplier CPU Voltage PCI Clock Synchronization Mode [Auto] Disable Disable 200. 00 100Mhz Auto Auto Auto Auto Select Menu Item Specific Help F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit 4-30 RYOBI A8N-SLI Series 4-31 Phoenix-Award BIOS CMOS Setup Utility Advanced JumperFree Configuration POST Check LAN Cable Pair 1-2 3-6 4-5 7-8 1-2 3-6 4-5 7-8 F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu [Disabled] Status Length Open N/A Open N/A Open N/A Open N/A Open Open Open Open N/A N/A N/A N/A F5: Setup Defaults F10: Save and Exit Select Menu Item Specific Help Enable/Disable Speech IC Controller -/+: Change Value Enter: Select Sub-menu 4-32 Phoenix-Award BIOS CMOS Setup Utility Advanced JumperFree Configuration PEG Link Mode [Auto] PEG Root Control [Auto] PEG Buffer Length [Auto] Select Menu Item Specific Help Enhance performance on PCIE serial graphics card. F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit RYOBI A8N-SLI Series 4-33 Phoenix-Award BIOS CMOS Setup Utility Advanced JumperFree Configuration Speech IC Reporter [Enabled] Report IDE Error [Disabled] Report System Booting [Disabled] Select Menu Item Specific Help Enable/Disable Speech IC Controller F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit 4-34 Phoenix-Award BIOS CMOS Setup Utility Advanced JumperFree Configuration Instant Music [Disabled] x Instant Music CD-ROM Drive Primary Master Select Menu Item Specific Help If enabled, power up by PS/2 keyboard function will be disabled. F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit RYOBI A8N-SLI Series 4-35 Main Advanced Phoenix-Award BIOS CMOS Setup Utility Power Boot Exit [S1&S3] [Enabled] Select Menu Item Specific Help Select the ACPI state used for System Suspend. ACPI Suspend Type ACPI APIC support APM Configuration Hardware Monitor F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit 4-36 Phoenix-Award BIOS CMOS Setup Utility Power APM Configuration Restore on AC Power Loss [Disabled] PWR Button < 4 secs [Instant Off] Power On By PCI Devices [Disabled] Power On By External Modems [Disabled] Power-On by RTC Alarm [Disabled] Date (of Month) 0 Resume Time (hh:mm:ss) 0 :0 : 0 Power Up By PS/2 Mouse [Disabled] Power Up By PS/2 Keyboard [Disabled] Select Menu Item Specific Help Press [ENTER] to select whether or not to restart the system after AC power loss. x x F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit RYOBI A8N-SLI Series 4-37 4-38 Phoenix-Award BIOS CMOS Setup Utility Power Hardware Monitor Q-Fan Controller Vcore Voltage 3. 3V Voltage 5V Voltage 12V Voltage CPU Temperature M/B Temperature CPU FAN Speed CHA1 FAN Speed CHIP FAN Speed x Q-Fan1 Stop Temperature x Q-Fan1 StartUp Temperature x Q-Fan1 Full Speed Temperature F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu Select Menu [Disabled] 1. 50V 3. 31V 4. 94V 11. 26V 48ºC 38ºC 4962 RPM 0 RPM 5443 RPM 20ºC 25ºC 72ºC -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit Item Specific Help Press [Enter] to enable or disable RYOBI A8N-SLI Series 4-39 4-40 Main Advanced Phoenix-Award BIOS CMOS Setup Utility Power Boot Exit Select Menu Item Specific Help Boot Device Priority Removable Drives Hard Disk Drives CDROM Drives Boot Settings Configuration Security F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit Phoenix-Award BIOS CMOS Setup Utility Power Boot Device Priority 1st Boot [Removable] 2nd Boot [Hard Disk] 3rd Boot [CDROM] 4th Boot [Disabled] Device Device Device Device Select Menu Item Specific Help Select your boot device priority F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit RYOBI A8N-SLI Series 4-41 Phoenix-Award BIOS CMOS Setup Utility Boot Removable Drives 1. Floppy Disks Select Menu Item Specific Help Use <↑> or <↓> to select a device, then press <+> to move it up, or <-> to move it down the list. Press <ESC> to exit this menu. F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit Phoenix-Award BIOS CMOS Setup Utility Boot Hard Disk Drives 1. Bootable Add-in Cards Select Menu Item Specific Help Use <↑> or <↓> to select a device, then press <+> to move it up, or <-> to move it down the list. Press <ESC> to exit this menu. F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit 4-42 Phoenix-Award BIOS CMOS Setup Utility Boot CDROM Drives 1. 1st Slave: XXXXXXXXX Select Menu Item Specific Help Use <↑> or <↓> to select a device, then press <+> to move it up, or <-> to move it down the list. [. . . ] 1st Slave: XXXXXXXXX Select Menu Item Specific Help Use <↑> or <↓> to select a device, then press <+> to move it up, or <-> to move it down the list. Press <ESC> to exit this menu. F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit Phoenix-Award BIOS CMOS Setup Utility Boot Boot Settings Configuration Case Open Warning Quick Boot Boot Up Floppy Seek Bootup Num-Lock Typematic Rate Setting Typematic Rate (Chars/Sec) Typematic Delay (Msec) OS Select For DRAM > 64MB Full Screen LOGO Halt On [Enabled] [Enabled] [Disabled] [On] [Disabled] 6 250 [Non-OS2] [Enabled] [All, But Keyboard] Select Menu Item Specific Help Press [Enter] to enable or disable. x x F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit RYOBI A8N-SLI Series 4-43 ™ 4-44 Phoenix-Award BIOS CMOS Setup Utility Boot Boot Settings Configuration Supervisor Password User Password Password Check Clear Clear [Setup] Select Menu Item Specific Help Supervisor password controls full access, <Enter> to change password. F1:Help ESC: Exit ↑↓ : Select Item →←: Select Menu -/+: Change Value Enter: Select Sub-menu F5: Setup Defaults F10: Save and Exit PASSWORD DISABLED !!! [. . . ]