ユーザーズガイド SHARP AD-AT10WA

[. . . ] A A A A A A A A A A A A A A A A A TINSZ1424AFZZ A0111. 0. 5MYM. YT ENGLISH INSTRUCTION MANUAL MAIN UNIT WALL BRACKET MODEL AD-AT10WA Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. [. . . ] Consult your local dealer for selecting the most suitable type of anchors. Mounting 1 Drive 2 screws a lightly through the wall by aligning them to the pattern paper D . Keep the screw head off the wall by 4 - 5 mm to hang the unit on it. 1 Mounting on wooden wall Mount the bracket on the firm and strong portion of the wall with certain thickness (5 cm or more). Never mount it onto thin plates such as veneer plate or boards (plaster boards). 2 Mounting on concrete wall Drill holes into the wall and hammer in the anchors b before tightening the screws a . The commercially available anchors b must be knocked into the wall until they are leveled to the wall surface. 2 3 4 g g Hang the wall bracket A on the lightly driven screws, and then fasten them tight. Drive the rest of the screws a in other holes. Fix the main unit bracket B to the unit c firmly using 2 supplied screws C . After hanging the main unit bracket B onto the hook of the wall bracket A , fasten both brackets ( A , B ) with 2 supplied screws C . • Be sure to fasten them with screws. If the unit is just hung on the hook, it may fall off. • Check the speaker cable connections. Notes: Screws may be loosened after hanging the main unit wall bracket. Clean the brackets with soft cloth dampened with neutral detergent. Never use organic solvents such as benzene, thinner, etc. Specifications Load capacity : Maximum outside dimensions : Weight : 5 kg or less 300 mm (W) × 145 mm (H) × 180 mm (D) approx. 1. 7 kg Use this bracket for recommended models only. Caution: Mount the wall bracket observing instructions in this manual. If it is not mounted properly, the unit may fall and cause injury or damage to people and the unit. Be careful not to jam your fingers in brackets whilst mounting. Make sure that the wall is firm enough to bear the unit. (Mount it at the portion where the reinforcing material is applied. ) Do not apply any other load to the fittings. [. . . ] Especially pay attention to small children. It may cause injury or damage to the unit. SHARP CORPORATION Printed in Japan [. . . ]