ユーザーズガイド SONY MZ-E90 annexe 1

[. . . ] (Three short beeps) Press (•+ once. Turn the control to ( •+ on the remote control. (Two short beeps) zPower Sources Using on a battery G Attach the supplied battery case to the player, and then insert one LR6 alkaline battery (supplied) with the correct polarity. [. . . ] The battery should power consecutive playback for about 10 hours before you need to replace it. The alkaline dry battery used together with a fully charged NH-9WM rechargeable battery should power consecutive playback for about 20 hours. Welcome! • DISC b • b HOLD No Welcome to the world of the MiniDisc!Here are some of the capabilities and features you will discover with the new MiniDisc player. GaAlAs 790 nm 400 rpm 900 rpm CLV • b • AC b ACIRC Lo BATT 44. 1 kHz • AC • b ATRAC ‘ ’ EFM • • Small body almost the size of a MiniDisc jacket Ideal weight and size; fits in your shirt pocket. • Shock-resistant memory offsets up to 40 seconds of optical read errors. • Low power-consumption design enables long playback with a single ”chewing-gum type” rechargeable battery. • Shuttle dial remote control with backlit LCD Keep the main unit in your pocket and operate the MiniDisc player through the shuttle dial on the remote control; The LCD diplays track information, playback mode as well as battery condition. Find the beginning of the current track Find the beginning of the next track When to recharge or replace the battery When b flashes in the display, the rechargeable battery or the dry battery is weak. Recharge the rechargeable battery or replace the dry battery . When the battery power is gone, ”LoBATT” flashes in the display of the remote control and the power goes off. Go backwards Keep pressing =. Each time you press the PLAY MODE button, the play mode indication changes as follows: (none) (normal play) All the tracks are played once. b PLAY MODE f v 1 • b= 2 Open the rechargeable battery 79. 7 14. 9 71. 9 mm compartment lid and insert the charged battery. v ”f” (all repeat) All the tracks are played repeatedly. • 80 g 120 g NH-9WM 1 1 1 1 1 3 Insert an MD. • 1 Push the OPEN button and open the lid. 2 Insert the MD with the label side facing up, and press the lid down to close. v ”f 1” (single repeat) A single track is played repeatedly. v ”f SHUF” (shuffle repeat) All the tracks are played repeatedly in random order. • • b 4 Play the MD. 1 1 Connect the headphones (supplied) to the remote control. 2 Connect the headphones with remote control (supplied) to the 2 (headphones)/REMOTE jack of the player. (Turn the control to (•+ on the remote control. ) The player starts to play the first track. 4 Press the VOL +/– buttons to adjust the volume. The volume will be shown in the display on the remote control. • • • 1 b Using other functions To know the track name and time C Press the DISPLAY button on the remote control while the player is playing an MD. Each time you press the DISPLAY button, the elapsed time of the current track and the track number, the track name and number, and the disc name and the number of the track recorded on the MD appear. Note Disc and track names appear only with MDs that have been electronically labeled. 1 1 1 • b AC • NH-14WM b 2 REMOTE AC-E15L NH-9WM, • • b VOLUME / b AVLS NORM • • — — — • * CPA-8 DCC-E215 *MDR-D55 MDRD77 MDR-E888SP SRS-A41 SRSA91 CKMD4 CKMD10 To stop play, press p. When using the remote control, a short beep sounds in the headphones. [. . . ] Each time you press the DISPLAY button, the elapsed time of the current track and the track number, the track name and number, and the disc name and the number of the track recorded on the MD appear. Note Disc and track names appear only with MDs that have been electronically labeled. 1 1 1 • b AC • NH-14WM b 2 REMOTE AC-E15L NH-9WM, • • b VOLUME / b AVLS NORM • • — — — • * CPA-8 DCC-E215 *MDR-D55 MDRD77 MDR-E888SP SRS-A41 SRSA91 CKMD4 CKMD10 To stop play, press p. When using the remote control, a short beep sounds in the headphones. The OPERATE lamp on the main unit will go off. [. . . ]