ユーザーズガイド YAMAHA RS70/85 戵־

[. . . ] Placement on a sloping, unstable surface or on steps may result in the instrument being unstable and overturning. Make sure all bolts are tightened firmly. Loose bolts may result in the rack overturning or parts dropping causing injury. [. . . ] When adjusting the height or angle, do not suddenly loosen the bolt. The pad may drop, the rack or pipes may slip, pinching or causing injury to hands or fingers. The rack may overturn or be damaged resulting in injury. Please be careful when children are close to or touching the product. The product has many pipes and arms so careless movement around the product may result in injury. When setting the pads and modules, please pay close attention in regards to the handling and setting of cables. Feet may become entangled in the cables resulting in falls. Do not put your hands or feet under the foot pedal or foot switch. Make sure only the supplied screws are used. Using any other screws may result in the unit falling off the holder or damage. Reattach the module holder to the holder clamp. 2 Setting up the parts • Loosen the bolts on the movable arms and legs, as shown in the diagrams below, then secure the bolts firmly once setting is complete. Follow the setup order (q-u) in the diagrams shown below. Caution : Make sure the bolts marked with a " setting up. " are loosened before 3-2 4 Attaching the cymbal pads Attach the cymbal pads to the cymbal holders and adjust their position, then secure in place. (Please refer to the Owner's Manual that came with the cymbal pads on attaching the cymbal pads. ) Module Holder Assembly e 5 Attaching the drum pads Attach drum pads to the hexagonal rod cylinder and adjust their position, the secure in place. DTXPRESS Step 4 Module Holder $ Caution Caution Step 3-1 Step 3-2 Holder Clamp Cymbal Pad ^ Right Leg Assembly w q Left Leg Assembly Cymbal Holder r t Side Arm (R) Assembly The hi-hat drum pad clamp can also be attached to this arm. Step 5 u Drum Pad Clamp Drum Pad y Side Arm (L) Assembly Make sure all bolts on clamps, pads, etc. , are firmly tightened. [. . . ] " are loosened before 3-2 4 Attaching the cymbal pads Attach the cymbal pads to the cymbal holders and adjust their position, then secure in place. (Please refer to the Owner's Manual that came with the cymbal pads on attaching the cymbal pads. ) Module Holder Assembly e 5 Attaching the drum pads Attach drum pads to the hexagonal rod cylinder and adjust their position, the secure in place. DTXPRESS Step 4 Module Holder $ Caution Caution Step 3-1 Step 3-2 Holder Clamp Cymbal Pad ^ Right Leg Assembly w q Left Leg Assembly Cymbal Holder r t Side Arm (R) Assembly The hi-hat drum pad clamp can also be attached to this arm. Step 5 u Drum Pad Clamp Drum Pad y Side Arm (L) Assembly Make sure all bolts on clamps, pads, etc. , are firmly tightened. Loose or over-tightened bolts may result in the part falling off and/or damage. [. . . ]